Question about Vacuums

Open Question

How do i clean dust filter for akai bagless vacuum cleaner model VC359

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

reddevil6
  • 1673 Answers

SOURCE: Kenmore Progressive Bagless vacuum cleaner

Check down by the brush roll to see if the inlet is clogged. This type of problem usually means there is a clog. But you do have a year's warr. on this, if you can't figure it out, then take it a Sears repair shop.

Posted on Jan 15, 2008

  • 184 Answers

SOURCE: Kenmore Bagless Issue

after cleaning the filter,replace the bag.But this time before you close the lid,make sure you remove the hose.after the lid is closed then put the hose back on.

leaving the hose connected to the lid after closing will create a gap between the bag holder and the bag.so just remove the hose first before changing the bag

Posted on Feb 07, 2008

SOURCE: HEPA Filter

http://geeksquad.fixya.com/ThreadView.aspx?prdid=618630&thid=730623
HEPA Filter
Posted by jenski66 on Jul 02, 2008
My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash?
Filter F27
Dirt Devil Purpose Cleaner for Pets
Upright Bagless Vacuum
Model #1LY2108-000


Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Typically the top filter of which is the sponge is washable but the HEPA filter is not, it can be brushed off and vacuum off with another vacuum, but the best filtration is to replace the HEPA filter and to wash the sponge filter, if the sponge filter get to bad then replace the sponge filter as well. Or, you can check with your local vacuum cleaner dealer in your area or to contact the manufacturer’s website and or phone #. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.

http://royalvacuums.com/ Customer Service 1-800-321-1134
Hours are: 8:00 AM to 7:00 PM (EST)
Thanks, Don the Vac Man
Go Ahead. Use Us.

Posted on Jul 02, 2008

  • 36 Answers

SOURCE: Pulse Bagless dust press system

Dear Customer

please check the following link for

Sanyo Instruction Manual Upright Bagless Vacuum Cleaner SC-150, SC-180

http://homeappliance.manualsonline.com/manuals/mfg/sanyo/sanyo_upright_bagless_vacuum_cleaner_product_list.html

please rate this,Thank u

Posted on Dec 16, 2008

EwingElect
  • 276 Answers

SOURCE: vacuum cleaner won't go - missing a step

In between the filters there's an access panel that can be removed - there may be a blockage there. You should also check your hose for a blockage.

Otherwise you may need to take it to your local Electrolux Service Center. There may be a problem with the pressure board. The machines have a 2 year warranty, not sure what it'd be in your neck of the woods.

Posted on Apr 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When you turn it on the lights on the battery come on and the brush roller will turn but the suction motor will not turn on.


Hoover Air Cordless Series 3.0 Bagless Upright Vacuum ...

www.amazon.com/Hoover-Cordless-Bagless-Upright...

Amazon.com, Inc.Hoover Air Cordless Series 3.0 Bagless Upright Vacuum, BH50140 ... The batteries come pre-charged, plenty to get up and running. ... The brush will stop as soon as the handle is in the upright position for like using the attachments. ..... and in need of charge, in carpet mode, the motor runs, but the brush roller won't spin.

Hoover Air Cordless Series 3.0 review - Best vacuum cleaner

www.vacuumsguide.com/hoover-air-cordless-series-3-0-review/

Rating: 4 - ā€ˇReview by Jason Roberts
Aug 4, 2014 - Hoover Air Cordless Series 3.0 is a new upright vacuum cleaner reviewed by ... power, 2 batteries - each lasting 25 minutes, good filtration system,light ... Just as in the case of the Linx, it filters dust particles, but doesn't come with HEPA filtration. ... Multi-Floor Cleaning - you can turn the brush roll on or off.

Dec 18, 2015 | Hoover Air Cordless Series 3.0 Bagless...

1 Answer

Doesn't seem to be sucking up dirt well


Bagless vacuum cleaners leave the bulk dirt in a receiver, but they still rely on a paper air filter to trap fine particles of dust. All the air that the vacuum moves passes through that paper filter. When the filter plugs up, it has to be cleaned or replaced. The bagless "primary filters" are much more expensive than vacuum cleaner bags, but if you can afford to replace it whenever the machine's suction is impeded, its the tidyest solution. You can remove the filter and tap it inside a waste can to dislodge some of the dirt that's plugging it. You can use another vacuum cleaner to clean it somewhat better than just tapping it. (It doesn't have to be *your* other vacuum cleaner, it could be borrowed, at the car wash, etc.) You can use compressed air to almost all of of the dirt plugging it, but you'll want to do it outside somewhere that making a clod of dust is acceptable or at least unnoticed. After a dozen or more cleanings the pores of the paper filter will become too plugged to clean well even with compressed air and it will have to be replaced.

Pet hair, sand and large particulate are least likely to plug these filters. Kitty littler, which is pressed pellets of fine clay, clogs these filters very rapidly. The clay pellets break up into very fine dust as they pass through the vacuum and whirl in the dirt cannister. Avoid vacuuming kitty litter, or any other fine clay into a bagless machine as much as possible.

Jul 28, 2012 | Hoover S3765-040 WindTunnel Bagless...

1 Answer

Hello,We have an Hoover Mach 5 Cyclonic vacuum that has no suction. We have cleaned and checked all hoses, belts & filters. Please help us.


With this model, remove the dust tank, and turn it on, check for suction at the lower intake. If you have suction, install the tank and remove hose, and check for suction there. keep following until youn lose it. Then you problem will be between those 2 areas

Mar 27, 2010 | Hoover U5194-900 Mach5 Multi-Chamber...

1 Answer

Filter cleaning


The fact is that the "bagless bandwagon" is powered by some excellent marketing that conceals what is often poor technology. In your case, the filter blocks because it's doing the job that a bag would do in a bagged machine (catching the dust), and then the machine overheats because the flow of cooling air to the motor is restricted. The only solution (for this machine) is to keep buying new filters - the only permanent solution is to buy a different vacuum cleaner. And my advice is to buy one with a bag!

Nov 03, 2009 | Dirt Devil M0105 Bagless Vacuum

1 Answer

New Eureka 5893 BVZ looses suction


eureka is about the most helpless website ever!!! did u try cleaning the filters?

Jul 05, 2009 | Eureka 5893AVZ Bagless Upright Cyclonic...

1 Answer

I need to clean the main filter


Be sure you wash the filter that is above the canister compartment. It has an orange lever to release it. I over looked this the first year I had the vaccume, dust was really caked in there. I also just wash out the inside of the canister with water once in awhile.

Mar 18, 2009 | Hoover U5194-900 Mach5 Multi-Chamber...

2 Answers

Blowing out dust


The reason most vacuums blow dust is because there is little or no suction in the foot of the vac. on this model, check to make sure that the hose is installed in the recepticle on the back to draw vacuum from the floor. verify the filter is clean, and there is no obstruction in the bottom foot.

Jan 18, 2009 | Hoover U5507900 Elite Rewind Bagless...

1 Answer

Dust blowing out of the side of vacuum


make sure that the filter in the dirt cup is in place.

Dec 30, 2008 | Eureka Whirlwind Litespeed 5740 Bagless...

1 Answer

Debris in front of foam filter


when that happened to me it was because the cup got full or was loose. I am now seeing the cup seal, located on the body above the cup, is not sealing and my filter is loaded. That might be a clue.

Jul 27, 2008 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

Bissel vacuum cleaner


That is the problem with a bagless, but if you keep the filters clean it won't be quite as dusty.

Jul 02, 2008 | Bissell 3594 CleanView PowerTrak Bagless...

Not finding what you are looking for?
Vacuums Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18387 Answers

D. Floyd Kolb
D. Floyd Kolb

Level 3 Expert

43501 Answers

Are you a Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...