Frigidaire aeq7000eso what is the capacity?

5.700 cubic feet. It is in the model number.

https://www.google.com/search?q=Frigidaire+dryer+model+CRWS5700AS0+capacity

..

Total Capacity (Cu. Ft.)
20.5
Refrigerator Capacity (Cu. Ft.)
15.27
Freezer Capacity (Cu. Ft.)
5.26

source
https://www.manualslib.com/manual/54236/Frigidaire-Ffht2117l-W.html?page=2#manual

Hi david sitler, thank you for your inquiry!

I see you are looking for the capacity of freon on the inside of your Frigidaire refrigerator, LGHC2342LF0. The freon capacity is very rare to locate for an refrigerator. I would recommend speaking with a professional to properly allow them to diagnose your appliance. Hope this is helpful. -Matt

Good Afternoon Friend,

I understand you want to know the capacity of your Frigidaire washer, model# FWT445GES2. After researching your model, I found that the capacity of your washer is 4.5 cubic feet. Hope this is helpful.

-Best Regards-
WP

Good Morning Friend,

I understand you are looking for the capacity of your Frigidaire washer, model# FWS933FS0. I show the capacity to be 3.0 cubic feet. I hope this is helpful.

-Best Regards-
WP

The capacity of the Fridigaire FWT449GFS0 is 2.7 cubic feet. I got this info from calling the Frigidaire toll-free help line. It is NOT part of the model number!

Frigidaire Affinity dryer model AEQ7000ESO error code E68 (stuck button). Sometimes a 'stuck button' code really is a stuck button. I took the circuit board off the front panel.On the back side of the front panel, each button has 3 short plastic posts, 2 on one side and 1 on the other.The center part moves to push a longer piece that contacts the circuit board. When I push the top of a front stadium-shaped button, the center plastic piece moves too far, touches the short post, and sticks (maybe due to age). When I push the bottom of the front button, the plastic piece goes far enough to contact the circuit board and not far enough to touch the short post. To prevent a stuck button, we now press the bottom of the front buttons.So far so good. If it happens again, I plan to shave or file a little bit off the top edge of the post to give it more clearance. 1st photo: pencil points to stuck parts. 2nd photo: unstuck parts, 3rd photo: the front of our dryer.

Hi

Thanks for using FixYa. No Heat issue in an electric dryer is usually caused due to three things mainly: Thermal Fuse, Wiring Harness and/or Heating Element. Start with checking the Thermal Fuse which is mounted inside the back cover panel to the exhaust duct and is mounted in white plastic housing. If thats fine then the Heating Element should be checked. Please do revert for further assistance.

Thanks
Rylee

what they are talking about if the fuses or circuit breakers in your house power panel.
it is not a part of the dryer but a panel in your house, usually in the basement or garage. sometimes they can even be in a closet in smaller homes.

It's in the model number, and it's 4.4 cft. Which is one of the largest capacity washers available.