Question about Dryers
Dryer does everything for certain amount of time then stops with f11 error code
Sorry to be the bearer of bad news. F11 indicates a fault with the main control board.
Sorry to be the bearer of bad news.
F11 indicates a fault with the main control board.
Posted on Nov 01, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Bosch Dryer lint filer warning
I also have a new Bosch dryer that dries for a few minutes and the lint signal buzzes. I finally figured out that most of the lint doesn't come out with the lint filter - it just gets jammed down into the vents between the dryer and the filter. If you can figure out how to get some kind of baby bottle washer into the space where the filter goes and get the lint to come out of those little vents - then the machine will dry much longer before the next time you have to give it the bottle washer treatment.
Posted on Oct 24, 2007
SOURCE: Electrolux dryer error code e61
There is a 'tech sheet' in the back pf the dryer. Unplug machine, Remove the access panel on the back to get to it. Reach in and it should be there. It will tell you how to do a button check. You have to enter a test mode through the buttons.
The E 61 is a stuck button.
Enter function test mode and perform key
stuck closed (active). (button) test to determine which button is at
fault. Carefully free the and perform the test
again. If button is free but the key struck code
still exists, replace electronic control.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
Posted on Sep 25, 2009
SOURCE: Bosch Condenser Dryer Classixx
I found this on justanswer.com, I am going to try it this weekend and I will post an update.
"Ok if you remove the left hand side panel then located at the back is the drain pump
remove the hose on it which goes up to the bottle and blow up it to make sure its clear.
If thats fine then remove the pump and clear any fluff thats in there and make sure the impeller is ok and turning fine.
Then refit and try again hopefully this should sort it out.
let me know if you need anymore info."
Posted on Jan 02, 2010
You need to remove the left side panel, this is the side where the drain container is, once removed you will see the drain pump with two pipes coming from it, remove the pipes and top cover, disconnect the wiring, remove the pump unit with the clip, clean the float unit and pump, also remove the congealed mess in the water trouth as this is what holds the float up and makes the machine think the drain container is full.
I bet you will find this will cure the problems you are having, it did with mine.
Posted on Apr 01, 2010
Tips for a great answer:
Jan 30, 2016 | Dryers
Nov 24, 2014 | Hoover Optima 7 OPH716DF White 600 mm...
Feb 28, 2011 | Hotpoint Aquarius WD640 Front Load...
Dec 20, 2010 | Washing Machines
Sep 26, 2010 | Hotpoint Ultima WF860 Front Load Washer
Jan 13, 2010 | Dryers
Dec 02, 2009 | Kenmore Elite HE4 Electric Dryer
Feb 23, 2008 | Kenmore Elite HE4 Electric Dryer
Dec 10, 2007 | Kenmore 46462 Front Load Washer
Jul 22, 2018 | Dryers
698 people viewed this question
Usually answered in minutes!