Question about Kenmore Elite 45986 Front Load Washer

1 Answer

Bad water pump

I have to be in Dallas, Tx. on Tuesday. what is the cost to replace the part?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 640 Answers

No one can give you a price,,because theres no set price in any one area..the cost of repair goes along with what area,,you live..and what company is servicing your unit..but if you need i will give you the basic price for the pump...its best to go to fixya.com and look at all servicers in your area...

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cost replace water pump


The cost of a water pump depends on where you live.
1. Where do you live? US, Canada, Europe?

Aug 06, 2014 | LG Washing Machines

1 Answer

Whirlpool WFW9150WW01 will not drain


New drain pump impeller maybe?otherwise complete pump i think

Jan 10, 2014 | Whirlpool Washing Machines

1 Answer

Gltf530ds0 cloths wet after spin


Hello Dallas Hart - Is the washer making a humming noise? If so, either the drain pump/hose is clogged and needs cleaning. If not, the unit may possibly be experiencing a communication issue with the control board, faulty door lock assembly, pump or timer. Contact a professional to move forward accurately and for an accurate diagnosis.

Feb 03, 2013 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Water leaks from machine during use. Have checked filter on right near base is clear.


Sounds like the water pump is going bad or a hose is leaking. Replace the water pump which in most cases are not, too costly. Most water pumps can be replaced from the bottom of the machine. If you can not find the part # on the water pump, look it up by the model # of the machine.

Aug 22, 2011 | Washing Machines

1 Answer

My washer will wash but when it reaches the rinse cycle the water comes out very slow and the clothes are still soaked.


it is probably due to a clog in the pump or hoses or the pump has gone bad. not hard to replace but somewhat costly

Jul 29, 2010 | Whirlpool Calypso GVW9959K Top Load Washer

1 Answer

I cant seem to get my GEwasher to completly drain. is it possibly the drain pump? I have leveled the floor, cleaned out the hoses and it still leaves about a gallon of water in the tub, and it smells after...


Hi I just went through this with the same brand of washer like 2 hour ago!!! I found a big clog in the drain pump that would not allow the water to drain.Disconnect your hoses and clean the opening of the drain hose! I am so proud of ME...my hubby could not figure this out....good luck!

Apr 02, 2010 | GE WBSR3140DW Top Load Washer

1 Answer

Tub does not spin. water pump works but no spin


  1. does the machine agitate? if no replace drive coupling between motor and transmission.If yes you have either a bad clutch or transmission.
  2. Remove cabinet and jump out lid switch to run with cabinet off.Put the machine in spin,look where the shaft goes up thru center of tub.Is the clutch drum turning?IF yes replace clutch.If not replace transmission.
  3. My guess bad coupling ,cost $20.
  4. Hope this helps .........Please rate my solution :)

Dec 14, 2009 | Kenmore Washing Machines

2 Answers

Machine empties water of the wash and rinse cycles all over the floor-no crack in the drain pipe - no sign of leakage in the drain hose attatched to the washer


Most likely have a bad water pump. If not you have a bad tub seal. Just hope it's the water pump. It's located just under the front. It's white and has either 2 or 3 hoses coming from it. Some models have 2 some have 3. No problem to replace and cost around $40.00. Good luck

Nov 17, 2009 | Kenmore Washing Machines

1 Answer

Will not drain water


If this is an older top loading washer. You most likely have a bad water pump. If it washes fine, you do have a bad water pump. It's no problem to replace and cost around $40.00.

Oct 13, 2009 | Kenmore Washing Machines

1 Answer

Whirlpool top loading washing machine not finishing cycle


SOUNDS LIKE A PUMP HAS GONE BAD. REPLACE IT. IT WOULDN'T COST TOO MUCH.

May 14, 2009 | Maytag Neptune MLG2000A Front Load Stacked...

Not finding what you are looking for?
Kenmore Elite 45986 Front Load Washer Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Jesus  Colon
Jesus Colon

Level 1 Expert

12 Answers

Fred Sops

Level 2 Expert

271 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...