Hesitation at higher speeds

No spark at the coil replace all spark plug wire and coil wire but start with fuel pump first it wont start anyways without fuel id look into a new cap and rotar with the plug wires might get lucky and find a distributor at a wreckers for the same price as cap and rotar

Someone will have to figure out if you are lacking fuel to the injectors or spark to the plugs to proceed with testing.
Could be a relay or several other things.

vacuum leak...bad air inlet hose at throttle body...underside...may also have bad motor mount

i would ck timing & replace spark plugs any way,,still should ck fuel pressure,,at fuel rail,,,

if your having cold engine start hesitation,you need to check the engine temp switch,it tells the computer how cold it is,so the engine can adjust to a rich start and not a lean one.if the switch is faulty and the computer is being told it is 80degrees,you will not get a rich mixture like no choke at all

Time to go get it diagnosed. Could be a tunup issue or cranks sensor or fuel pump. You most likely have a code stored to help diagnosing

If it works well at speed and acts up when slowing or stopped it doesn't sound like fuel filter or pump. You can try running injector cleaner through the engine to clean the carborator injectors or fuel injectors if you have those. Look at replacing the plugs and wires on the motor.

Have someone press on the gas petal while you feel the exhaust coming out of the tail pipe.It should have more exhaust coming out as the petal is pressed farther down. This method is checking for a restriction in your catalitic converter. A high flow type is best. Also make sure your air filter is clean and nothing blocking your air filters intake.

What you have the cap and rotor.could be bad use good one.

Check primary voltage at ignition coil and fuel injectors, engine cranking, use a test lite, dark green wire with orange tracer. If no voltage, that comes from asd relay. Some makes and models if the computer doesn't see the cam and crank sensor signals, the computer won't ground the relay.
You need to do some testing.