Burning errors Burning fails error 80041459.

You can get a lot of help from www.bleepincomputers.com

easy, that happened to me and what I did was just took a cotton swab, alcohol and wet it. Then I opened the cd device and smothly clean the eye of the reader, blow indirectly to it's surface and ready!
easy solutions for big troubles, enjoy.

REPLACE DVD RW DRIVE

my dvd not burn dvd or cd but read

Their could be several possible reasons and solutions for the above error, basically what is happening is for some reason the CD/DVD burning software is unable to determine the Optimum Power Calibration rate (a small pre-burn test to determine optimal laser power for writing), resulting a disk burn failure. There is no easy way to pinpoint the exact reason, so try all the possible fixes from top to bottom (easy to hard) and see what works:
Try using different brands of quality blank media, most common reason for such error's is cheap blank media.
Try burning at lower speeds (Highly effective).
If this fails try a different burning software

your barning has problam is lanz and meczaminzam problam

problem in the drivers and the burning software

http://support.gateway.com/s/issues/260121793.shtml

try using a burning program wothy of the attempt.real player works off a basic set of drivers and fails on many occasions. if your burning from dvd to dvd use dvdfab version 5.0 or higher. this will right past any copyrights. or if burning from files use nero version 7.0 or higher. anything less is a waist of time.

Do you have a dual layer burner, you need one to burn dual layer dvds that may be your problem hope it helps