Question about Toilets & Bidets

2 Answers

Saniflow leak Hi, I saw your post on Fixya, i have the exact same problem, did you find out what the issue was? Thanks Dean snivlem1975@aol.com

Posted by on

  • rkorby May 11, 2010

    No one has come-up with an answer yet.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My sani-flo hooks into the pipe that the laundry uses and if both are used at the same time it leaks this might help

Posted on Apr 27, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Dean:

No solution yet.

Posted on Jan 14, 2009


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Leaking macerator unit


Shut off water supply and check where the leak is. Loosen the joint , reconnect it securely and reclamp. Before reclamping spray Stop Leak around the joint. Slowly open water supply. Goodluck.

May 30, 2013 | Toilets & Bidets

1 Answer

Saniflow runs, but not straight after flushing


Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will definately help.

Jan 30, 2013 | Saniflo Toilets & Bidets

1 Answer

Saniflow keeps blocking with hair


It is but this is something you must put up with. Make sure though everything is tightened well.

Jan 23, 2013 | Saniflo & Saniplus& Macerator Pump

1 Answer

Opening a saniflow unit


Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will definately help.

Jan 16, 2013 | Saniflo & Saniplus& Macerator Pump

1 Answer

Pump randomly runs


This problem maybe caused by a slight weep of water from the cistern the saniflow has a sensitive float system , once level is reached the unit will turn on until required level is acheaved again . So check toilet bowl to see if the is a trickle of water if so you need to take a look at the flush system in your cistern.

Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html

Nov 17, 2012 | Saniflo & Saniplus& Macerator Pump

1 Answer

Saniflow wont pump


If your Saniplus macerator won't pump and the motor is humming or spinning slowly it is 95% likely that the internal motor capacitor has failed - most common problem with these units

I have posted repair instructions here:

Saniplus repair instructions

May 29, 2012 | Saniflo & Saniplus& Macerator Pump

1 Answer

My saniflow is pumping to a fall and when flushed it blows the plug out of the sink i fitted air admittancs valves as recomended , how do i solve the problem


you have a venting issue, air admittance valves are not for venting purposes, although they do work in some situations.

you may need the services of a plumber to solve your venting issue.

Jul 19, 2010 | Saniflo Toilets & Bidets

1 Answer

Do the saniflow toilet need to be plumbed in to mains waste? I have a patient who needs a toilet located outside the house that needs to be trouble free


Hi and welcome to FixYa, I am Kelly.

In short yes it will need plumbed with a smaller drain line to the home waste drain.

The unit uses a fast-rotating blade to reduce waste and toilet paper in the flush water, which is immediately and entirely released under pressure through "small-diameter piping" to the sewer or septic tank. No special maintenance is needed and the pump is sealed for life. This simple and cost-effective alternative to conventional plumbing is ideal for basement renovations and other home-improvement projects. Properly sized, a Saniflo macerating system can handle all the fixtures in a bathroom, including the sink, shower, tub and toilet & endash; even on a septic system. What's more, these fixtures will work up to 12 feet below and as far as 150 feet away from a septic tank or sewer line.


Go to this page and download the manual for the installation instructions:

http://www.saniflo.com/Downloads.aspx

These are all the installation downloads available on that page:

Installation Instructions:

SANIBEST SANIGRIND SANIPLUS SANICOMPACT SANIPACK SANIALARM SANISHOWER SANISWIFT SANIVITE SANICUBIC Classic SANISTAR SANITOP

Thanks for using FixYa,

Kelly

Jun 01, 2010 | Toilets & Bidets

1 Answer

Water leaking out of breather


I have a question, I have a saniplus no problems hooking it up filled the tank and then flushed it..On the discharge end I had a small about of water puddling up at the pressed in rubber fitting. Every clamp was tight not sure what the reason is any ideas. I thought about silcone around the rubbber seal between the lid.

Sep 08, 2009 | Saniflo SaniPlus-Round SaniPlus Macerator...

2 Answers

Shower tray is low and fills before saniflow kicks in cant alter height of tray


See if you can adjust the highth of the saniflow,to make it kick on sooner. goodluck.

Jul 13, 2009 | Saniflo 013/005/007 Sanibest Toilet with...

Not finding what you are looking for?
Toilets & Bidets Logo

Related Topics:

712 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toilets & Bidets Experts

john h

Level 3 Expert

7133 Answers

Mike

Level 3 Expert

4331 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Are you a Toilet and Bidet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...