Question about Onkyo TX-SR705 Receiver

1 Answer

Onkyo TX SV7M Knocked out by Power Surge

We had a desert snow storm and the power went out while the receiver was operating, now the receiver only turns on, no sound at all.  Any help would be appreciated.

Posted by on

  • buddha1964 Jan 05, 2009

    Thanks, I will try this.  How can one tell the protection circuits are blown.  

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Try pulling the plug out of the wall for 5 min or more,give the unit a chance to reset.Hopefully you didn't get a power surge that might have blown the protection circuits.

Posted on Jan 03, 2009

  • larrchev Jan 05, 2009

    Easy,go back to your original problem.deeper analysis requires a service tech's test of the main circuit board.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hdmi out is not working in my onkyo tx-sr333. Neither is the audio when switching to fm radio. All after a storm. It was plugged into a surge protector.


A surge protector may not be able to react fast enough to prevent damaging spikes from reaching the sensitive circuitry . You think of using Isolation stages for power. as for the amp plug in headphones to check if the audio DSP stages are intact.

Jun 25, 2015 | Onkyo Audio & Video Receivers

1 Answer

Onkyo tx-sr604 help


You said you tried hooking the HDMI up directly from the TV to each component, and that worked. How is it usually hooked up - through some kind of switch? I'm not completely understanding your setup here.

Aug 10, 2007 | Onkyo TX-SR604 Receiver

1 Answer

Onkyo TX-SR604: Video in from cable box has taken increasingly longer to display a picture.


I would at least disconnect all units from power for a while and then reconnect to allow the units to reboot.

Oct 30, 2012 | Onkyo TX-SR604 Receiver

1 Answer

Had a power surge and now my Onkyo TX-SR607 will not power on. Only get a constant click sound. Any repair advice?


although power surge can trigger activations of protection circuits,

there are at times, damage is done before it is activated.

• Check first for low power supply regulators,

then check for possible output stage failure.

let me know if you need further assistance!

Sep 09, 2012 | Onkyo Tx-sr607 7.2-channel A/v Surround...

1 Answer

My onkyo tx-ds575x lost power in a storm and now I get no audio from it. The sony bravia tv has sound but the onkyo won't send it to the speakers.


Hi,
Please reset Onkyo receiver that will solve noisy sound problem, to reset the receiver, press and hold Video-1 button on unit and press Speaker-A button. Display will show *Clear* that means receiver has been restore on default settings, turn it On and check sound.
Hope this will help.
Thanks.

Apr 06, 2011 | Onkyo Audio & Video Receivers

1 Answer

I have an onkyo tx-sr706 had a storm and now the protective circuit i think is activated and when i turn it on it wont stop turning off and on repeatedly?? what do i do or is it broke?


If the protector is working the fault can vary from a very simple failure like a fuse in the power section to a major failure of the boards being cooked up.
so take a look into the set and replace the fuse or a surge protector in the mains or maybe the primary of the transformer.
If not there are many sides to this isssue.

Aug 30, 2010 | Onkyo Audio & Video Receivers

1 Answer

After my house was it by lightning my Onkyo


If your receiver was connected to any power source and that power source was not a surge protector strip there may be damage to the receiver as lighting travels. Another thing to consider is the fact that many people will put their equipment on surge protectors but the cable is still connected to the TV etc...This is just another avenue for the lightning to get into the home and blow up your system. I always disconnect any cable from my computer and TV. The power source from the wall is also unplugged when there is a storm just to be sure. Surge protectors are limited in their use as well. I don't believe they can take too many lightning hits. It is best to change them out.

Jul 18, 2009 | Onkyo HTR500 Receiver

1 Answer

I have a model TX-SV7M Onkyo tuner that has a broken on/off switch. Where can I get it fixed.


I believe that the power switch for that model is available generically. Open up the unit and take a look. You should be able to find a similar switch from an on-line electronics supplier.
Dan

May 07, 2008 | Audio & Video Receivers

Not finding what you are looking for?
Onkyo TX-SR705 Receiver Logo

Related Topics:

522 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onkyo Audio & Video Receivers Experts

D. E. Hev

Level 3 Expert

1059 Answers

gbob59

Level 3 Expert

2963 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you an Onkyo Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...