Question about Broan-NuTone Intermediate Whispaire WA6542SS Stainless Steel Kitchen Hood

1 Answer

Fan blade broke off

I need a new fan for mines.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 38 Answers

Part # K7458-000
1-800-363-0566

Posted on Feb 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My downdraft vent no longer removes cooking fumes and smells for days after cooking. We have changed the screens, but still have residue coming from the vent inside the cabinet. Does this vent need to


Remove the motor together with the blower wheel, go to the local self service car-wash and use the engine de-greaser cycle (if not available, buy a can at the auto supply, spray the fan blade and let sit for a while) and get all the grease of the fan blades. make sure the fan blades are cleaned thoroughly. the fan will now ran quietly and will remove all the grease away. in the future, clean the filters often.

Jan 06, 2014 | Range Hoods

3 Answers

Noisy fan or motor?


HI. The most common issue here will be with a loose motor shaft. This is the part that the fan blades are mounted on. When this occurs, the looseness will cause the motor, and shaft to wobble, thus, causing this noise you here at high speeds. The wobble is less violent during the slower speeds, so it is not loud, in this case.

The second issue will be a warped fan blade. This will cause the fan to rub against the shroud, thus, creating the noise, as well.

If the shaft is loose, or bent, the entire motor will need to be replaced. Now, if the fan blade is warped, you can, simply, unscrew the blade from the shaft, and replace it(on most model)

Dec 11, 2009 | Broan-NuTone Allure III QS330SS Kitchen...

1 Answer

Fan has a humming noise and locking up


a.if there were a dead bird inside, you'd know it from the smell! if the outside vent has the proper hood on it, it's doubtful a bird could get into it. possibly a roof-rat, but still- the smell!
b. have you 'de-greased' the filter lately? clogged filter can cause airflow problems, as well as allowing fan blades to become greased up and unbalanced, which could cause a noisy condition. if you can- remove the filter unit and check the fan blades for crud. use a gentle application of windex, rubbing alcohol, or some other gentle solvent to clean the blades. the leading edges usually pick up the most crud. you should be able to see this! carefully, using q-tips, or a small brush, clean off the crud! the fan's probably out of balance. WD40 works pretty well, too. also lubricates the shaft bushing that the blades are attached to. make sure the fan is turned off! duh!! good luck! also- soak the filter in hot water and a good de-greaser for a while, 'til you can see light through it. it's probably aluminum mesh- so use very hot water and a goodly amount of 'grease cutting' dish detergent. rinse well.
once again- good luck! the filter is probably held in place by clips. once removed, you will probably need a flashlight to work on the fan blades. put paper towels, or newspaper down to catch drips!

Sep 29, 2009 | GE ZV750SY Kitchen Hood

1 Answer

The fan makes a very loud noise


the fan blade may be loose on the motor shaft there is a set screw on the blade center you can tighten (it needs to be very snug)

Aug 22, 2009 | Kenmore 51841 Kitchen Hood

1 Answer

Range master 50000 exhaust fan stopped working


Extremely likely the fan motor.  get to it then , after removing fan blade,plug it in directly to a 110v  outlet ,just for a second to see if it works well( don;t touch it while prefoming this test,only the plug), or jumper out the switch(with electric disconnected) momentairly to see if the fan runs after turning the electric back on. 

Jan 07, 2009 | Rangemaster Kitchen Hood

1 Answer

Wobbly Fan----Nutone Whispaire WA6500


Definetly need a new blade

#K7458-000 Boan/nutone part number

Dec 09, 2008 | Broan-NuTone Intermediate Whispaire ...

1 Answer

Attic roof vent fan- brand unknown. need motor and blade


Any Blade will be ok if it will fit shaft and they all should be cosistant and of course the higher the amp the better quality.I like the Pro 3 model at Home depot but I believe the Pro 1 gable is the 12 inch blade,pro 3 is 17 inch houseing and maybe 12 inch also.

Please rate jj505 Guru

Jul 11, 2008 | Range Hoods

4 Answers

Fan blades or motor in Nucor over the stove hood


it is hard to get the fan off. but if you are carfull you can do it. but any large home improvment store can help with a new fan.

May 03, 2008 | Range Hoods

2 Answers

Vibration at high speed


check these causes fan blade brackets,fan blade for cracks, any grease on blades.

Dec 27, 2007 | Broan-NuTone Allure® I WS136BC Kitchen...

Not finding what you are looking for?
Broan-NuTone Intermediate Whispaire  WA6542SS Stainless Steel Kitchen Hood Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Broan-NuTone Range Hoods Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Are you a Broan-NuTone Range Hood Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...