Question about RCA RS2653 Shelf System

Open Question

Rca rs2653 standby light stays on and unit will not turn on

The standby light remains on - if i do not use the unit for a while it will not turn on unless i unplug it first.
any help will be greatly appreciated.
thank you
mike

Posted by on

1 Suggested Answer

  • 277 Answers

SOURCE: rca rs2653 a disc with no scratches will skip, tried cleaning

its the disktry the rubbers mite be worn

Posted on Dec 11, 2009


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony HCD LX20i audio shelf sysyem won't turn on. Standby light flashing. Disc stuck in it.


Check the speaker wires for shorts, if okay! suspect the audio output ic's, the protection circuit won't come out of standby because there is a short.

May 06, 2012 | Audio Shelf Systems

1 Answer

So I connected 8 speakers to this system and I might have blown it out. when i connect it the red standby light comes on. then when i press the power button the screen goes blank as if turning on but...


Audio output shorted out or blown fuses in power supply check all fuses if fuses are good your Audio out put transitors or I.C has been shorted out as a result of impedence over load in future dont connect speakers in parallel in those small Audio units.

Natureisland technician

Commonwealth of Dominica

Nov 06, 2010 | Sony CMT-HP7 CD Shelf System

2 Answers

Unit does not turn on or display time


do you mean a power surge, if so the surge may have overloaded the elctronics,=cooked ,so afraid is u/s

Jul 07, 2010 | Fisher SLIM-3010 Shelf System

1 Answer

Sharper Image SA260


activate the reset button on the back of the unit (you'll need something like a toothpick or a needle to do this) this should do the trick (it did for me) hope this helps

Jun 16, 2008 | Sharper Image SA260 CD Shelf System

1 Answer

Standby


I had the same problem. I can't fix it, and neither could RCA customer service. The only way I could think of was to find a surge protector extension cord that had a on/off switch to make it easier to turn on. Another solution might be to buy a cheap wall timer, the kind you use to turn lights on/off. That resets it every day and it should be OK.

May 15, 2008 | RCA RS2653 Shelf System

2 Answers

SCREEN PROBLEMS


Try unplugging unit for 24 hours then, retry. Unit may also have problem in standby circuit, have serviced

May 06, 2008 | Kenwood HM-331 Shelf System

1 Answer

Power Problem? My DS55 red standby light blinks at me and won't turn on.


I agree with your diagnosis. If one channel quit and the unit now ocassionally won't output at all then the amp is going into protect. Have it serviced.

Sep 20, 2007 | Aiwa NSX-DS55 CD Shelf System

1 Answer

Help


No, I doubt if the surge device is causing your problem. most likely there is a power supply issue, or a fauly with one of the servo or motor driver circuits. This is not a repair or a quickie fix for the end user I'm afraid. This unit is going to need to be taken into a repair shop to be diagnoised. Good Luck

Jun 13, 2007 | Sony MHC-GX450 CD Shelf System

1 Answer

Power Problem


Its not a typical repair that a do it yourselfer can do unless youve had troubleshooting experience on microprocessors. Your problem could be the 5 volt power supply is not filtered clean when it warms up or the reset voltage falls too low for the micro. good luck

May 19, 2006 | RCA RS2650 Shelf System

Not finding what you are looking for?
RCA RS2653 Shelf System Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Audio Shelf Systems Experts

The Knight
The Knight

Level 3 Expert

68368 Answers

Cindy Wells

Level 3 Expert

4761 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a RCA Audio Shelf System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...