CHECK FILTER LIGHT COMES ON UNTIL I START DRYER

need to check the filter relay

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tom_db3a51ff0ca57f20

its not an error but a reminder. its normal operation tp see it everytime you power on thw dryer

take out and make sure you have puched it as far as it will go by takeing it out and putting it back should **** the sencer switch with is at the back of the filter not on the filter its self its in the dryer at the back where the filter puchs at it keep takeing it in and out ok if that dont work try cleaning at the back of the filter in the dryer where the filter go's ok should do it it only takes a little bit of fluff to stop it from working ok

The CHECK FILTER light will appear between every cycle, simply as a reminder to clear the lint filter before starting a new load. If the unit runs properly, then this is no cause for concern. If it will not start, then the unit may require service.

check the outside part of the vent hose and make sure you ahve good air flow.you may need to replace the sensor

Hi friend,,,
welcome to fixya
try to unplug it for 30 minutes this should reset the control board. and clear any errors it has. and may start working again. let me know how it goes OR
try this to get it in diagnostic test mode have the dryer in standby mode then press and hold more time and less time and then press the power button to get out of this mode you will have to unplug the unit for at least 1 minute

if your satisfied with my solution PLEASE RATE IT

thank u...

Try removing the lint filter from the dryer and with no clothes, start the the dryer, and if it works then replace your lint filter.
Tip: Fabric softener sheets in the dryer can deposit an invisible coating on the screen of the filter and reduce air flow.

Check the door switch first.Than look for possible thermal fuse has cut off.

For Sgt 48 - You are not reading the original message very well - The original help question didn't say they saw check filter at the beginning or end of a dry cycle they indicated that the dryer STOPS MID DRY and says check filter - this is not a friendly reminder, it is indicating something is wrong and the filter needs to be completely cleaned out (and past the filter down in the interior of the dryer) and if that does not work then you need to also check the dryer hose for kinks, lint build up, etc. Lastly, reset the dryer by unplugging it (or flipping the breaker) for a minute or so and hold down on the start/pause button for 8 seconds while it is unplugged (this will reset the error code for check filter, among other things).

The check filter light comes on every load to remind you to clean the lint filter. Cooling only happens when that light is flashing not when it's on solid. If this is a gas dryer check the exhaust hose and vent on the outside of the house. If it is blocked it will not let the unit get to the correct temp due to cycling.