Question about Lexmark T650n Laser Printer
900 firmware error
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
OK, a couple of things... Some earlier Lexmark units had code on both a RIP board (raster image
processor) and an engine board. In this case, the code would have to be reloaded into both
boards. Fortunately, this can be done even if the printer will not boot to a ready state. However, if
this has already been done sucessfuly, the problem may well not be the printer but rather something
in the data stream. To confirm this, remove any and all data cables and reboot the printer. If it comes ready and you can print all the internal pages including the network config pages, then it is likely the
problem is the data stream. One must be careful when the printer is controlled by a print server
because the end user may not have control over the print que. If a corrupt or printer incomprehensible
job is stuck in the que, the printer will go to a 900 condition as soon as the network interface
initializes. This will continue until the print que is cleared.
Hope this helps...
Posted on May 01, 2009
SOURCE: 900 Firmware error on lexmark
Within your printer there is a micro-processor and a memory chip. The Firmware is a piece of software that is loaded to a memory chip.
Error of the software has occurred, you therefore may need to flash the firmware of the printer.
Find the Firmware on the Lexmark website, be sure to get the EXACT one for your printer.
Remember a failed attempt will render your printer useless, contact a professional to flash the fimware if you are unsure.
Posted on Apr 14, 2011
Tips for a great answer:
May 27, 2011 | Lexmark X204n 4-in-1 Laser Printer
Apr 14, 2011 | Lexmark X544dn All-In-One Laser Printer
Mar 25, 2011 | Lexmark X204n 4-in-1 Laser Printer
Before you download firmware, the 900 error usually indicates a software or communications problem. Please try to do the following.
Disconnect every cable, except for the power cord and turn off the printer for 30 seconds or more to clear its memory
Jan 17, 2011 | Lexmark Optra T620 Laser Printer
Jan 07, 2011 | Lexmark X204n 4-in-1 Laser Printer
Mar 10, 2010 | Lexmark X204n 4-in-1 Laser Printer
Jan 21, 2010 | Lexmark X204n 4-in-1 Laser Printer
Dec 13, 2007 | Lexmark Optra T620 Laser Printer
1,219 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: