Question about Electrolux UltraLux 2000 Bagged Canister Vacuum

2 Answers

Electrolux upright bag light stays on even when bag is not full

The bag light is on and I even put in a new bag and it does the same thing. It also makes a louder noise while it is running than before.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I took the hose off and discovered it was clogged very tight. There was a piece of a 3 inch wire also stuck in there. Thank you for your quick response. Have a great New Year!!!!!

Posted on Jan 03, 2009

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 44 Answers

Once you change the bag, be sure to turn the machine off and back on to clear the fault. If it is the full bag light that is on, and not the "?" light, and you have a new bag in place, then you probably have a bad control valve. I would suggest finding the closest Aerus (formerly Electrolux) dealer and having them change it. It shouldn't be too expensive. If you have the "?" light illuminated, the bag probably isn't pressing the actuator like it should. When placing the new bag into the machine, be sure the bag top presses the small button in the lower right hand corner. Good Luck!

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My electrolux vacuum cleaner?


Sometimes the bag isn't installed properly.
Try removing the bag and replace with a new one making sure that the bag is in the bag compartment squarely on all four corners thus covering the bag door switch. Close lid and try again.
Hope that helps!

Mar 14, 2015 | Electrolux Vacuums

1 Answer

I have the electrolux guardian-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes....


Hi,
Check your hose you have something stuck in the hose...stretch it out straight and run something through it to push out whatever is stuck in there...

heatman101

Apr 29, 2010 | Electrolux Guardian Bagged Canister Vacuum

1 Answer

Electrolux 2100 vac dies when you attach hose even with new bag.


If the bag full light keeps coming on, you can first try adjusting the dial on top of the vacuum cleaner. If that does not work, then you need to change the control valve. This is an internal component of the canister and is directly below the dial. You will need to follow the instructions on a previous post to open the Electrolux plastic canister vacuum, and remove the bage cage. Once you remove the bage cage you can change the control valve, and this will solve your problem with the bag full indicator.

Mar 31, 2010 | Electrolux UltraLux 2000 Bagged Canister...

1 Answer

My electrolux 2100 does not turn on. the light bag full comes on even with a new bag


The bag might not be seated properly or you are using the wrong type bag.Try reseating the bag.

Jan 20, 2010 | Electrolux UltraLux 2000 Bagged Canister...

3 Answers

My electrolux vac shut off for a full bag. After replacing the bag the vac won't start and the bag full light stays on.What should I be looking for to resolve my problem?


If the suggestion that renevacdoc did not work, it is most likely that your valve assembly(full bag control) has gone bad and needs to be replaced. You will have to take your vac to the Aerus/Electrolux dealer/service store for repair.
Joe

Nov 07, 2009 | Electrolux UltraLux 2000 Bagged Canister...

1 Answer

Bag full light


the sensor for your electrolux vacuum bag checker needs to be fixed.

Jul 03, 2009 | Electrolux Vacuums

1 Answer

Vacuum won't stay on


When you open the canister you eill see a little rubber hole that senses when your bag is full. This must be clogged. If you have another vac try to vacume all the dusr from this hole and any other opening inside the vacume that you can reach. I hope this helps. Don't forget to rate this answer.

Feb 07, 2009 | Electrolux Epic 6500 Vacuum

2 Answers

My Electrolux upright worked fine


Are you using the proper bag? There's a kill/reset switch that needs to be pushed down by the rim of the bag before the unit will run.

Jun 22, 2008 | Electrolux Epic 6500 Vacuum

1 Answer

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly


The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full bag sensor is engaged. This second switch is supposed to get reset when you push the on/off switch on the outside of the machine. The full bag shutoff switch was stiff and it, therefore, was taking a couple of presses of the on/off switch to move the shutoff switch back into the running position.

Jun 19, 2008 | Electrolux Epic 6500 Vacuum

4 Answers

Full bag system works properly, but doesn't reset easily


Either there is something wrong with your switch. Which it doesnt sound like it. Take it to your dealer or call another one it sounds like the control valve needs to be replaced. I am a dealer 1-866-966-9350.

Jun 19, 2008 | Electrolux Lux 7000 Bagged Canister Vacuum

Not finding what you are looking for?
Electrolux UltraLux 2000 Bagged Canister Vacuum Logo

Related Topics:

306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Electrolux Vacuums Experts

Roger Potts

Level 3 Expert

694 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18304 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you an Electrolux Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...