Question about Hotpoint 24 in. FDW60 Free-standing Dishwasher

2 Answers

FDW85 Dishwasher Hi there. I also have a DEMO problem on my FDW85 dishwasher. Have tried holding down the on/off and start/reset buttons very hard as suggested but it's not resting it. Any other ideas ? Many Thanks

Posted by on

2 Answers

Re: FDW85 Dishwasher

Hotpoint FDW85 dish washer. Power is on, program is selected but the program will not start when I push the start button nothing happens the time to go on the program just flashes.
Any idea's

Posted on Dec 21, 2007

Re: FDW85 Dishwasher

Turn on your dishwasher and press and hold the start/reset and on/off buttons simulaneously until the display shows d.of this turns off the demonstration mode.

Posted on Sep 13, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Dishwasher stuck in demo mode. How do I get out of this

Holding down the start button and on/off button for about 10 seconds should clear it.

Dec 06, 2015 | Bauknecht Dishwashers

1 Answer

Reset button maytag dishwasher

  • 1 Open and close the dooricon1.png of your Maytag dishwasher.
  • 2 Locate the "Rinse" button on the dishwasher control panel. Press and release the button five times in quickicon1.png succession.
  • 3 Press and release the adjacent "Drain/Off" button on the control panel two times; this will deactivate the dishwasher's demo mode and reset your dishwasher.
  • If you need to restart your dishwasher or forgot some dishes and want to open it during a cycle and restart it

  • 1 Press the "Cancel Drain" button on the display. Allow about 2 minutes for the dishwasher to completely drain.
  • 2 Choose a cycle under "Cycles" on the panel.
  • 3 Select an option or options under "Options" on the panel.
  • 4 Push the "Start Resume" button.
  • Oct 24, 2013 | Dishwashers

    1 Answer


    yes you need to reset dishwasher to time fill.turn off the power button wait 10 sec,push and hold the programme and start buttons then turn power back on.hold buttons down until display lights up then release programe button until 4 shows in display,then press start.test dishwasher. F4 is an inlet fault.

    Jun 07, 2010 | Asko 24 in. D3350 Dishwasher

    1 Answer

    Dishwasher AEG FAV40620W stuck time delay

    Thanks. I figured it out from the online manual. Hold buttons #2 and #3 (second and third button down on far left side) for 2 seconds should reset it. It took some 15 minutes however before the dishwasher reset!

    Peter Smith

    Jan 27, 2009 | AEG 24 in. Favorit 40650 Free-Standing...

    5 Answers

    Ariston LD 87 Demo displaying and wont run

    I pushed the "power button" and the "start button" together for some seconds, and then the dishwasher was ok, and didnt run the Demo longer.

    Jan 24, 2009 | Kenmore 17024 Built-in Dishwasher

    3 Answers

    Fdw80 stuck on demo

    Hold start and on /off button togerther then will reset.

    Dec 08, 2008 | Hotpoint 24 in. FDW60 Free-standing...

    2 Answers

    Hotpoint Ultima dishwasher dwf70

    Press and hold the start and the on/off buttons together. It should come out of demo mode.

    Aug 25, 2007 | Hotpoint 24 in. FDW60 Free-standing...

    3 Answers

    Ariston LL64 doesn't start

    1) Ensure the dishwasher is turned off.
    2) (may not apply) Turn the plastic blue lever located under the sink to the vertical position (this opens the valve, so water can go into the dishwasher)
    3) Pour powder indo the dishwasher
    4) Turn the dishwasher controller to the top position (the 12 o’clock position) – this is the eco-setting.
    5) Press the on/power button on the dishwasher, so that it now turned on (a light will display)
    6) Move the dishwasher controller to the “R” position (it’s on the very left), and leave it there a second or two.
    7) Move the dishwasher controller back to the eco-setting (the 12 o’clock position).

    Jun 23, 2007 | Ariston Technologies LL64WNA Built-in...

    1 Answer


    When the support engineer says press the 'on/off' button and 'start/reset' down together, press very hard. Press hard for 5-6 seconds and a the wording 'demo off' appears for a split second, then resets its self ready for use.

    Aug 30, 2006 | Hotpoint 24 in. FDW60 Free-standing...

    Not finding what you are looking for?
    Hotpoint 24 in. FDW60 Free-standing Dishwasher Logo

    1,053 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Hotpoint Dishwashers Experts

    Mike Cairns
    Mike Cairns

    Level 3 Expert

    3053 Answers


    Level 2 Expert

    157 Answers

    Donald DCruz
    Donald DCruz

    Level 3 Expert

    17129 Answers

    Are you a Hotpoint Dishwasher Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides