Question about Casio Parts Cash Register PC Desktop
TRYING TO END THE YEAR SO I CAN START WITH 0.0 FOR THE NEW YEAR
Have you had periodic reports setup on this machine? If you do daily reports, then you need to use the periodic report mode (Z2) for a yearly report. Try turning to Z2 then press 1 then CASH.
Make sure the top of the report shows 'Z2' and not 'X2'. If it shows the X then it probably hasn't been setup for periodics.
Posted on Jan 03, 2009
Tips for a great answer:
Jun 24, 2016 | Cash Registers & POS Equipment
Jan 26, 2016 | Cash Registers & POS Equipment
Nov 25, 2015 | Cash Registers & POS Equipment
Sep 20, 2015 | Cash Registers & POS Equipment
Jul 03, 2015 | Cash Registers & POS Equipment
Remove upper casework:
WARNING! - RISK OF ELECTRIC SHOCK.
Ensure power to the ECR is off and the power cord is disconnected before connecting the interface.
a. Locate the power switch and switch off the ECR. Also disconnect the ECR from the mains supply.
b. Unlock and remove the printer cover (by tilting it up from the front).
c. Remove keys from mode locks etc.
d. Remove the grey name-plate located half way down and to the left of the register.
e. Remove the single screw located behind the panel (bottom right of printer mechanism).
f. Push in the two tabs located either side of the register and slide the top cover forwards. The cover should now lift upwards, away from the register.
g. Move the top cover on to its side towards the right of the register (take care as there are still cables linking the top and bottom halves).
May 28, 2015 | Cash Registers & POS Equipment
188 people viewed this question
Usually answered in minutes!