Krx-89 stand by light wont turn off

Krx-89 stand by light wont turn off - Fixya

www.fixya.com/support/t14712608-krx_89_stand_light_wont_turn_off

Oct 20, 2012 - krx-89 stand by light wont turn off Stero doenst play is it because thestand by light is on? How do i turn off - Kenwood Audio & Video Receivers ...

How do you turn off standby on a kenwood krx-89 stereo ...

www.fixya.com/.../t15447523-turn_off_standby_kenwood_krx_89_ster...

Dec 20, 2012 - Hi, is the red light that says power On? If not, it could just be the fuse since I had the same problem. If you take the lid off, it should be in the left ...

Read - Document Download

There is a powerbutton on my sony TV - no amount of pressing the remote will activate the telly unless I forstpop the power button on the top. Once it has been initiated teh remotes work fine.

ALSO check the remote is working by activating a digital camera - can even be a smartphone - point the remote at the lens and you should see a flashing light on the camera screen, if not, check the batteries etc (try another remote for something you know is working to compare the result)

If all that fails, it may well be the TV that's broken.

Sounds like a blow out to me.

I have a KRX-792 and I am getting volume but when max it only sounds like a 1 or 2, any ideas?

Check by setting the remote control by an other setup code to your device. If you wish to get more setup codes, three digits, four digits or five digit ones, check this link. Pull up older posts. Setup code list and proceedings to some popular model remote controls are given.

Hi, is the red light that says power On? If not, it could just be the fuse since I had the same problem. If you take the lid off, it should be in the left rear and is a 250v 6amp fuse. I had the same problem where only the standby light and the input lights were on. Neither the radio and cassette lights were on.

Typically, 4 blinks mean "Vertical Deflection Stopped." Chances are that you have a problem on the D board.

More than likely either the ignition control module, the stator or the pick-up located in the distributor.

I thought that I had the same problem. I then discovered that when I put 3 CD's in it started up on it's own. If you push the demo button you can see how it's supposed to light up the number of tracks in a square on the right of the display. It wasn't doing that until I put in all 3. Then it started up and I was able to use the disc 1, 2 & 3 buttons to change from 1 CD to the next and I used the Up and Down buttons to change songs and the play button above the tape deck is multi-functional. Hope this helps.

I'm having the same problem:(
I need to solve this urgently, i can't stand always being removing the batteries... please help me!!!