Igniter won't ignite

Inspect the old ignition cycle which is out.Is there any problem noticed of Ignition cylinder getting worn out.
Because when issue of ignition not turning off,its faulty ignition lock cylinder or faulty ignition switch.I suggest re-inspect the new ignition cylinder.
For more help,click the help link mentioned below:----

Ignition Switch Will Not Turn Off?
http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html
----------------

1995 Ford Taurus: Ignition switch not turning OFF?

http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html

-------------

Ignition Problem Troubleshooting

http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html

------------------

These will help.

Thanks.

sounds like the igniter is faulty try a local h/ware or plumbing shop for a new piezo ignition

Replace the "igniter switch assembly". The igniter's are getting a weak spark and since you have one that will not spark at all, this is the usual problem. Here is the assembly to order.




The part comes with a 365 day, any part, any reason return policy.

many things will cause no start problems could have faulty ignition switch.use test light see if power going to starter if not check ignition fuse to starter.if power going to starter, more likely starter solenoid or starter faulty.if ignition fuse okay and starter and solenoid okay still no start problem could be in the ignition switch or inhibitor switch faulty.code scan for faulty theft security system which will also cause no start conditions.

Check the coils that have been replace for bent or broken prongs that plug into the ignition control module and if nothing looks damaged then i would think the ignition control module is faulty.Replace ignition control module.

Have you check the fuel pump

First check your fuel pressure it should be 41-47 psi with key on and engine off if its below 32 psi replace the fuel pump and filter.If fuel pump checks out to be good then take ignition switch out and check for burned ignition switch wires and worn ignition key tumblers and ignition lock cylinder.These cars are known for faulty ignition switches and ignition lock cylinders.Ignition switch gets to hot then it won't start until it cools off.

Sounds like you might have a faulty ignition switch and ignition lock cylinder.These cars are known for the ignition switches getting hot and then they won't start.

I have had this happen on my 98 Voyager. Just have a new key cut. This new key will sometimes cure the problem. The older keys get worn out and won't unlock the ignition. Try this before a much more expensive and time consuming change of the ignition.