Question about Hotpoint Aquarius WF000 Front Load Washer

1 Answer

Stuck in wash cycle

My washing machine keeps getting stuck in the wash cycle. it will wash forever unless the cancel button is pushed. it will rinse and spin fine it just you have to then mannualy select the rinse /spin cycle and press the start button. oh its a hotpoint front loader. its reasonably new i.e it dosent have a mecanical/ clockwork program selector. any advice greatly appriciated. ta pete.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,462 Answers
Re: stuck in wash cycle

Check if heating by putting on as hot wash and feeling the door. if no heat, check continuity thro the heater - modern heaters have a non-resettable cut-out in them which can cause problems. no heat then no program advance

Posted on May 08, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Cotton program stuck on wash cycle with 1 minute left

Control board needs to be replaced. Many times the control boards go bad because of a spike in the electrical grid cause by a brown out, lightening strike or even a surge in the power. After the control board is replaced... I suggest using a surge protector on all of your electronic devices including the washing machine.

Feb 06, 2014 | Hotpoint Ultima WF865 Front Load Washer

1 Answer

Rinse cycle gets stuck

Most models have a timer relay that times out when a cycle is over. It may be located behaind the front panel - It's worth a shot

Oct 15, 2009 | Washing Machines

1 Answer

Wsher stops in the rinse cycle wiht a n F4 message

f2 error means long drain or no drain
check the drain pump
replace drain pump if nessesary

Mar 17, 2009 | Kenmore Washing Machines

1 Answer

Help with whirlpool awm 8103/1

Okay, ther manufacturer recommends unplugging the washer for at least 30 minutes to reset the computer. It could be you have a momentary glitch causing some problems. If you still have the same problem after leaving the washer unplugged, the following link explains the "FH" error code:

If your clothes are stuck inside and you still cannot get them out because the door will not unlock, you will have to use the manual release to open the door. The next link explains how:

I hope this helps you. If you require additional assistance, please let me know.

Aug 27, 2008 | Whirlpool GHW9300 Duet Washer

1 Answer

HE3 Front loader Controls Locked

Try 'end of cycle' pushed down till the light goes off. Or locate the button with diagram of 'lock', & push down till the light goes off.

Dec 24, 2007 | Kenmore 3.8 cu. ft. HE3 Front Load Washer

1 Answer

Kenmore Front Loader stuck in "LOC" and every button produces "ERR"

Look for the 2 buttons on your that have a lock symbol.  Pushing & hold both for 3 seconds.  This toggles the child proof mode.

Nov 20, 2006 | Fisher and Paykel Fisher Paykel Intuitive...

Not finding what you are looking for?
Hotpoint Aquarius WF000 Front Load Washer Logo

561 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts


Level 1 Expert

5 Answers


Level 1 Expert

47 Answers


Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides