Question about Roper REX3614KW Electric Dryer

1 Answer

Warm air but clothes not drying

Hi..I have a roper rex3514rq1..the dryer blows warm air but not hot enough to dry clothes..Will I have to replace the element? If so, could you provide a repair guide and the part needed..thanks..John

Roper by Whirlpool/heavy duty/exlcap/3 cyc

Posted by on

  • Thomas F. Schneider May 11, 2010

    The ROPER support page is very unhelpful(see below) bought out by Whirlpool in Canada but the model numbers do not cross over. 
    Yes, I beleive you wil have to replace the eliment. Isolate and test it with an ohm meter to be sure. It should have a high resistance reading. Parts can be found many places on the internet or local appliance parts places.






    http://www.roperappliances.com/support/

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Roper Master
  • 3,463 Answers

Make sure u have seleced the high heat setting..The fact that it is heating more or less indicates that the element is o/k.
Check and clean any filter(s) that u can see,it is more likely to be a thermostat problem than anything else. and there are at least 2 of them, also check line voltage is correct.
Plz rate this solution.
thanks.

Posted on Jan 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

NOT DRYER CLOTHS LIKE IT USE TO TAKING MUCH LONGER


Check for clogs in the vent air line. If dryer lint or some obstruction is slowing the air flow it will take longer to dry clothes. Also the dryer may not be getting hot enough. Check to see if the clothes feel hot or warm when you reach inside. If it feels hot enough it is likely an issue with air flow. heat and air flow are required to dry clothes.

Oct 02, 2010 | Frigidaire Electric Dryer

1 Answer

Whirlpool dryer does not get hot enough to dry clothes.


Clean/repair the dryer vent. If the airflow is restricted the result is the one you just described.

Good luck,
Vlad
First Choice Appliance

Apr 20, 2010 | Roper REX4634KQ Electric Dryer

1 Answer

Dryer does not get hot enough to dry clothes Roper REX4634KQ1 Electric Dryer


The vent may be stopped up, or the vent hose crimped so the air cannot escape, you can check the air flow at the vent on the outside of the house while the dryer is running.
try cleaning the vent and the lint screen with a vacuum cleaner, you may need to replace the vent hose, this should solve the problem

Jun 02, 2009 | Roper REX4634KQ Electric Dryer

2 Answers

Dryer gets hot but wont dry clothes


Do you know if the dryer vent is free of obstructions?Check outside where the dryer vents outside ,and see if the air is weak or flowing freely.If it is not clogged the air should be pretty strong from the vent outside.If it has blockage it will definitly take longer to dry your clothes.

May 17, 2009 | Roper RGX4634KQ Gas Dryer

1 Answer

Warm heat..clothes not drying


john there is only one heating element.ither it works or it dosent.when acustomer complains of low heat or long dry times 99out of100 its the venting or the dryer is blocked with lint.remove the dryer from the venting and try a load.if better clean house venting.you .........if not better you should have a great air flow leaving the dryer so if not drying well with venting off.take dryer apart a clean all araes that air is moving,where lint can block that flow.god bless .tom

Jan 01, 2009 | Roper REX3614KW Electric Dryer

2 Answers

Dryer does not get hot enough to dry clothes Roper REX4634KQ1 Electric Dryer


Most common cause of this is a clogged venting going to the outside to test this remove the vent from the back of the dryer and run a load if it drys ok them you know you have a venting issue and will need to be cleaned out if not plz repost and we can look deeper into it

Jul 15, 2008 | Roper REX4634KQ Electric Dryer

1 Answer

Dryer not drying


Check your lint filter. Put it under running water to see if the water goes through it. Chances are it is clogged up. Wash it and put it back. Should do the trick.

SGt 48

Jun 18, 2008 | Roper Dryers

1 Answer

Needs 2 drying cycles


I am assuming you are cleaning the lint filter. Check the vent pipe out the back. If it vents into the wall, the piping leading to outside may be plugged. Your washer is spinning the clothes good, right? If the clothes are excessively wet they will take longer to dry also. If its practical, remove the vent hose and let it dry blowing into the room. It may suck but just once for a test.

Mar 06, 2008 | Roper REX4634KQ Electric Dryer

3 Answers

Dryer does not get hot enough to dry clothes Roper REX4634KQ1 Electric Dryer


Either the heater element is breaking or is loose and getting only 110V instead of 240V.  First I would check the wall outlet with a voltmeter for 240V between Line1 and Line2.  Also check the connections and continuity for the heater element.

Oct 11, 2007 | Roper REX4634KQ Electric Dryer

1 Answer

Clothes Hot but damp, water out of vent


Is this a combo washer/dryer in 1 unit? water shoud not come out if it is just a dryer. Your air coming out of the back vent hose should be hot. If your clothes comes out of your WASHER damp (more than normal) then your washer is not spin drying good enough. (worn belt, clogged drainage system).

Jan 09, 2007 | LG DLE2532W Electric Dryer

Not finding what you are looking for?
Roper REX3614KW Electric Dryer Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Roper Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Roper Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...