Hello - After further researching it does not seem that there is an actual diagram available. However you may try the following steps to clean out the coin trap on an Affinity washer. Please be very cautious and it is actually recommended for this to be done by an actual certified technician. 1. Unplug the unit. 2. Tilt the unit up to where the front feet are in the air and the back feet are still on the ground. Please make sure the unit is propped up safely. 3. Now that the unit is propped up look inside on the bottom right hand side there is a black looking accordion thing. This is the coin trap. 4. Clean the drum out with as much water as possible and have towels ready. The next step you will have the remaining water come out. 5. At the top of the coin trap where it is attached to the drum is a silver spring with a silver screw. Loosen the screw and wiggle the coin trap down from the drum. 5. Reach inside the coin trap and clean what is inside of it out. 6. Put the unit back together following the same steps backwards
Hello Robert Reische, thank you for your inquiry!
I understand that your Frigidaire washer is showing an "E23" error code. Based off the information I show "E23" stands for drain pump relay on board failed or wire off the pump. Which means you could have an issue within the main control board or wiring to pump. Since it could be any one of these underlying issues I would recommend having a technician come out to properly diagnose and repair your appliance. Hopefully this helps. -Matt
272 views
Usually answered in minutes!
×