Wide Screen Problem (Pincushion)

Sir did you replace the lamp, if you replace the lamp you should reset the lamp hour meter. Feel free to send feed back good day and best regards.

Hi there
i read your report. Yes it will support your 24'' wide screen monitor. I have same card as you and a monitor also. so you must be a gamer like me lol . Ty for writing to fix and have fun.

Best Regards Richard

well, there are two options

rite click on the desktop screen

properties------settings and then change the screen resolution which best fits u

OR

if the settings were changed from the monitor then use the buttons on the monitor and there is an option to reset it to default, do that

this should work

Good morning! kindly try the following:
-mouse pointer on the screen, right click the mouse, then click the Properties, then click Settings tab, then click Troubleshoot or Advance which will guide you in setting your screen display. best regards.

Hi,

Your post/description indicates a "pincushion" problem; the width problem is as you have stated.

There are two (2) possible reason for these problems:
1. component failure in the horizontal section of the monitor. These components could either be a diode, a capacitor or a resistor. In some cases there are trimpots in the PCB that can be adjusted to correct these problems;
2. component/connection failure in the controller section.

Of the two, I tend to suspect #1 as highly likely the case. Repairs such as this would require that you be familiar and comfortable working with electronic components and circuitry, the use of a DVM and a soldering iron. Should this be not to your liking, your next best bet would be to seek the services of a qualified professional.

Hope this be of help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

What i belive is that the hinges of the screen are loose.I would suggest to cointact there tech support and get them replaced.

Monitor Help CH000241, No display on the monitor. CH000242, Distorted or skewed image on monitor. CH000243, Monitor has a tint of one color.

Good Luck, Please dont for get to Vote/Thank You.

LG Studioworks 563N Monitor horizontal width is exceeding out of screen and not able to adjust it along with pincushion through menu. IRF S630A Transistor replaced, no effect. Pl. help.

CRT monitors suffer from the so-called pincushion effect. It is the curving of the actual video picture usually inwards on the sides. There is often an adjustment to compensate for this and it's usually situated near the other user controls. Look for it in you manual.

Now, because of magnetism differences in the world. The monitor is setup to work where it was built. The pincushion effect get worse over time. The degree of severity depends on the location of the monitor and the quality of the design of it to facilitate enough future re-adjustment by turning the pincushion knob.

If the menu is appearing then it should be able to adjust the Monitor, provided you have replaced the micro switches. Check for continuity by pressing the buttons. I don't think that there is any prolem with other components.