Question about Canon imageRUNNER 2200

1 Answer

Meter location on a Canon IR 2016

Does anyone know where the meter is located on this machine?

Posted by on

  • lfielder Dec 30, 2008

    Thank you very much!



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert whose answer got voted for 20 times.

  • Expert
  • 168 Answers

Shoold be a button around your keypad that says counter..

Posted on Dec 30, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jura impressa s8, the display shows" please wait" and doesn't switch to the Coffee Ready.

This error is because:
1- Flow meter is blocked & not sending signal of water flow.

2- Entire hydraulic system is filled with Calcium deposits and slowed down flow of water.
1- Open the machine and manually clean flow meter. It is located between the water tank & the pump.
2- Follow this by manually descaling the machine. Seelink. Do not use automatic descaling method suggested by Jura.
Stop using Filter cartridges as the machine reminders for descaling are silenced by use of filters. Services Unlimited Inc Parts Guru Since 1988

Apr 22, 2016 | Jura Capresso Impressa S8 Coffee Maker,...

1 Answer

Kenmore Electric Dryer model 88042700 does not go on. There are no lights going on and now power. Dead. The house circuit breaker is not tripped - no signs of any kind of distress on the back. It is 4.5...

Find someone who is handy with a multi-meter, or an ohm-meter, and let them look for you. Obviously, you could do this.
Check to see if the plug has current on the straight lugs, should show 110 v. each.
Open the back of the machine where the cord attaches, and check there next. Should have 110 v. on the left and the right screw/nut. The center screw/nut should be grounded.
Next steps will be opening the back and or the bottom of the machine and looking for the problem.
If you have to pay a service man, most of them will recommend a new machine, and will still charge you some bucks to check it out. At my daughters house, she just paid 75 to have it checked, and to be told, "You need a new one!"
I don't know what service people charge in you area, but parts and labor could cost you big bucks, if you don't :"Know anyone".
Be blessed.

Sep 01, 2013 | Kenmore Dryers

2 Answers

The meter on our Savin increased 5x the normal color reading in one month and we haven't used the copier any more than normal. Our paper consumption hasn't gone up, nor our toner consumption....

Could it ???? That's a good question... I have seen the meter stop working. I don't know, but did anyone try to manually change the hard counter? Maybe your service company may have your copier set in service mode to click twice for 11 x 17 or for two sided copies? One test you can do is to write down the meter reading and make ten copies and recheck the meter. If it clicks ten times, the meter is working and try making four 11 x 17 copies and look at the meter to see if it clicked four times. If the meter is working correctly, your service company is ripping you off or they are billing the wrong company.......

Mar 22, 2013 | Ricoh Aficio 450 Copier

1 Answer

Can anyone help locate a manual for a Necchi Alco A709-5 sewing machine??

Try Googling (necchi)(A709-5)(manual) without parens.

Jun 15, 2017 | Sewing Machines

1 Answer

Installation instructions or owners

The screen voltage to screen grid of the CRT is above than normal. Try to adjust it by adusting screen pot meter, can be located on its LOT.

Mar 02, 2012 | Televison & Video

1 Answer

Help! hotpoint aquarius condenser dryer

More than likely thermostat or heater.
Located at rear of dryer behind removeable panel, you will need a meter to test them.

Jan 28, 2010 | Hotpoint Aquarius WF000 Front Load Washer

1 Answer

On start up the washer show F1 Ihave to hit pause start 3 time

The F1 fault is indicating a problem with the main machine control board assembly. It may be going bad but the only way to know for sure is to do some electrical testing with a volt/ohm meter and the wiring diagram located within the appliance. If possible use the meter and the wiring diagram to check input/output voltages looking for discrepancies between the diagram and the actual meter readings.

TheRepairGuru ---

Jan 27, 2009 | Whirlpool Cabrio WTW6600SBT Top Load...

1 Answer

Parts needed

contact Shriro located in NSW

Dec 15, 2008 | Gaggia Classic Espresso Machine

1 Answer


These are older wide format machines
I would check with www.digitales

How many feet are on the meter?
and was the copier under a service contract?

these items will help determine resale value
usually people want to know if the machine is passing a clean copy as well.

May 09, 2008 | Xerox 8830 Copier

2 Answers

Washer fills with water , then shuts off , doesn't move to another cycle

Since you know about the lid and check switches, they are located under the splash (control)panel. unplug the machine and remove the screws holding the panel on. Using a meter check the switches for continuity and replace if they've gone bad.

Jun 06, 2007 | Maytag Neptune MAH5500B Front Load Washer

Not finding what you are looking for?
Canon imageRUNNER 2200 Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts


Level 3 Expert

102366 Answers

old marine
old marine

Level 3 Expert

2005 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides