61 error fault

SOURCE: Mitsubishi WD-62525 yellow blinking status light

Check that the lamp door is closed all the way. There is a saftey switch that closes from the door being on all the way. If not the status light will keep blinking. There is also a switch on the air filter door.

SOURCE: My 2006 WD-65732 has sound but no picture.

Sounds like your lamp is out, change it.

SOURCE: wd 62327 DLP red 3 blinks 1 steady red light

Call for waranty repair if less than 3 months old.

SOURCE: WD-62725, no picture, no sound

Hi,

Your power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Good luck in solving the problem...

SOURCE: My 73'' mitsubishi model #wd-73738. Is flickering.

Hi!
That's a clear indication that you have a bad power supply in your TV.
If you know how to DiY...I suggest you open your TV. Locate the power supply section, it is where the end of the power plug is connected. Replace all blown or bulge or leaked capacitors with same value. That will fix your TV problem.
The hardest part is to disassembling your TV cover, cause you will need to pry off the snap in lock at the edge of your TV.

Power supply board should look like this. Examine the capacitors in the board


After replacing blown capacitors...it should work again.


Things you will need.
1. A plastic flat end screw or any object with flat ends....to fry off the cover
2. Soldering iron.
3. Soldering lead
4. Soldering pump.
5. Flat and Philip Screw
6. Replacement capacitors (of same value with the blown one) that you can buy to any electronics store.

Or try replace light engine..if the above solution won't work..