Question about Canon BubbleJet i560 InkJet Printer

1 Answer

I have a canon i560 ink jet printer. the yellow light flashes and the message reads The used ink tank is full. it won't print anything

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 8,637 Answers

Normal 0 Could have a corrupt driver.
Disconnect the printer or at least be sure it is turned off. I'd do both and when the CD software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud

Posted on Jan 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Black not printing


Canon Bubble Jet i560 Ink Jet Printer not printing black

Aug 01, 2010 | Canon BubbleJet i560 InkJet Printer

2 Answers

The waste ink well is full


Reset Procedures for Canon i560 Printers
  1. Turn off i560 Printers
  2. Hold down Resume button and press Power button.
  3. Keep holding down Power button and let Resume button go.
  4. Press Resume button 2 times then let BOTH buttons go.
  5. Green lights will flash and then stop blinking.
  6. When green lights are solid, press the Resume button 4 times.
  7. Press the Power button and the printer should turn off, if not, press the Power button once more.
  8. Your Canon i550, i560, i850, i860, i865, i9100, i9950 Printers should respond as normal.
  9. Please remember at some time of other you will need to clean out the ink pads that are inside the printer.
Please all I ask is call back and just gave a vote, it will gave me some satisfaction to know am helping some one, so I will keep on helping.
All The Best: Pineworks

Feb 22, 2010 | Canon BubbleJet i560 InkJet Printer

1 Answer

The yellow color does not print. I have just


Most of these new type printers have an air line that blows the ink on to the page while printing once the little air jet is clogged or falls off not much of anything you can do other then get a new printer or take it to a repairman to have that jet replaced. Hope this helps

Nov 10, 2009 | Canon BubbleJet i560 InkJet Printer

1 Answer

Printer acts normal , no error codes, prints but no color


Without a computer, you can print a test page by holding the resume button until the green light flashes 2 times, one flash will do a printhead cleaning. If you enter the mode where you did the reset, and press the resume 2 times and the power button once, it will printout a page of printer data.

Sep 15, 2009 | Canon BubbleJet i560 InkJet Printer

1 Answer

How do I empty the use ink tank?


You can still order the ink absorbers for this model, but only a shop can access the diagnostic mode to reset the counters and clear the error code.

Jun 21, 2009 | Canon BubbleJet i560 InkJet Printer

2 Answers

When i turn my printer on the light flashes green once and then orange 5 times. cannot get past this stage - any ideas?


Here are all the flashing explanations:

Two flashes: Out of paper or paper feed error

Reload the paper correctly and press the RESUME/CANCEL button.

Three flashes: Paper jam

If paper has jammed in the printer, clear the jam, reload the paper in the printer correctly and press the RESUME/CANCEL button.

See Paper Jams

Four flashes: Empty ink tank

If you press the RESUME/CANCEL button, it will continue printing with an empty ink tank. After printing is finished, replace the ink tank immediately. If you continue printing with an empty ink tank, it may cause damage to your printer.

Refer to your Quick Start Guide for instructions on how to replace an ink tank.

Five flashes: No print head installed/Defective print head

Install the print head. Also, ensure that the protective tape has been removed.

If reinstalling the print head does not solve the problem, replace it with a new one. Contact the Customer Care Center.

Eight flashes: Waste ink tank almost full

The printer has a built-in waste ink tank for the ink used during print head cleaning. Eight flashes indicates that the waste ink tank is nearly full. Press the RESUME/CANCEL button to cancel the error so you can continue printing. Before the waste ink tank becomes completely full, contact the Customer Care Center.

Mar 08, 2009 | Canon BubbleJet i560 InkJet Printer

3 Answers

Printer Not Responding, 7 orange flashes


Don't replace the print head soooo fast...

Take the print head out first and clean the gold contacts...
I used a very fine sandpaper like emery cloth...

You might get 4 yellow blinks after that.
That is because the printhead was turned upside down to clean and the ink looked low and/or out.

Just wait a few minutes after cleaning and reset...
Mine worked fine after that.... smile....

Aug 09, 2008 | Canon S900 InkJet Printer

2 Answers

Canon i560


may be ink level is too low,check it first,make sure delete the all pending documents
regrads
prasanna

Mar 07, 2008 | Canon BubbleJet i560 InkJet Printer

Not finding what you are looking for?
Canon BubbleJet i560 InkJet Printer Logo

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Printers & Copiers Experts

kakima

Level 3 Expert

96683 Answers

old marine
old marine

Level 3 Expert

1479 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Canon Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...