Question about Starvision SP-7VGA11 Pixelon 7" Monitor Entertainment with Headrest Shroud

1 Answer

One of my screens shows the video upside down

How do i get this to correct

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers
Re: One of my screens shows the video upside down

It could be that the monitor was installed upside-down; other than that, check the settings on whatever device your feeding video to the screen with- a PC, a DVD player? It might have rotation settings.

Posted on May 23, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Screen wont work on my tview d74ts in-dash touch screen

Is it wired correctly? Red wire to switched ignition accesory, such as the factory radio was? Yellow to battery? Are their fuses intact?

How about the ground wire? Or did you just secure that to the dash? If so, that metal piece may not have a ground connection to the body shell, or the engine.

Jun 01, 2012 | Car Video Monitors

2 Answers

The picture on screen is upside down

Jay there should be a External Switch on the Screen,Try looking ttech

Jul 25, 2007 | Legacy LSWR844 8.4 in. Car Monitor

1 Answer

I have a Digitax F2 taxi meter. The display will not set the correct tariffs and only comes up with the numbers 666666. Can you tell me how to reset, "flash" the meter. Thanks.

I just had this problem with my Digitax f2.

My car came out of the garage after 3 days.

The meter turned on, and displayed the correct date, time, and year.

I returned home \'till I went out to work at 10pm.

When I went out to work, I took my first fare, and tried to start the fare on the meter.

It showed error 666666.

As I drive a Hackney, it is illegal to work without a meter.

Consequently, I had to go home, and loose a nights work.

The next morning, I went to my local Digitax rep, and had it fixed with their Microchip Key, in a couple of minutes.

The rep told me that as the cars\' battery had been removed, and replaced, this action had disabled the meter.

The moral of this story is when you get your taxi back from a garage, make sure that your Digitax meter is working properly, by setting a fare.

Also, make sure that you pick up the car in time to get to your local Digitax rep, to get any problems fixed the same day.

Oct 04, 2011 | Sony F2 Taxi Meter

1 Answer

I have a axxion portable dvd player when i plug it in the green charged light amedietly comes on but it wont charge and it wont turn on

ensure it is the correct plug for appliance sometimes does not go in far enough, I found out after the expence of new batteries

Jul 10, 2011 | Car Video Monitors

1 Answer

Peugeot 206 stereo says locked

It says LOCKED because wrong codes have been entered previously

To reset , leave SWITCHED ON...UNDISTURBED for as long as it takes to automatically reset itself

This may take an hour or more

Make sure you have the correct code

Apr 21, 2011 | Blaupunkt Car Video Monitors

1 Answer

My legacy 15.1 monitor dont want to show pic just show blue screen and says no signal

Hey jag0717
Many problems arise down to physical component issues so try these things before trying anything else.

  1. Double check all cables are correctly inserted
  2. Make sure power is being sent to all devices in the loop
  3. Try the source (Set-Top box, Games Console) on another monitor first if possible
  4. Make sure the monitor is set to the correct output. (HDMI, VGA, Compenent)
After all this has been tested you can easily isolate the problem to be down to the monitor itself.
Let me know the results and good luck!

Mar 05, 2011 | Legacy LMR15.1 Roof Monitor

1 Answer


On the Back of the DVD Player there are probably two blue wires. One is for the amp turn on and the other is the power antenna wire. Whats happening is when you turn the radio on the blue used for the power antenna is trigger and puts out a 12vlt signal to push the power antenna up.. So when you look at your factor car sure the wires are correct..on one wire is gonna be for the amp turn on and the power antenna. use the amp turn on the to a different wire that is connected to the factory amp. You can get a diagram from your dealership. With the correct wires in the right positon, you will get sound out of your vehicles speakers.

Oct 25, 2008 | Car Video Monitors

1 Answer

Slave hard drive

No io don't see the disk in there.

\Yes, the jumpers is the clip you remove and re position.

Jul 08, 2008 | Car Video Monitors

Not finding what you are looking for?
Car Video Monitors Logo

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Starvision Car Video Monitors Experts

xxxxxx xxx

Level 3 Expert

4681 Answers

Custom Exchange
Custom Exchange

Level 3 Expert

397 Answers


Level 3 Expert

57295 Answers

Are you a Starvision Car Video Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides