Question about Air Hogs Glow In Dark Havoc Stinger Rc Helicopter

1 Answer

Wont fly it will spin but it always veers off to one side and cant get natural flight

Posted by on

  • Senterion02 Feb 15, 2009

    I can get it off the ground but I can't get any kind of control. It just goes straight up but when I try to get any kind of control in elevation it just cuts off. It either goes full power or no power. Their is no inbetween.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have an Air Hogs havoc cyclone stunt plane. I am not sure if your plane has this, but on my plane's remote there left and right steering trim buttons. Play around with these until your plane flies correctly.

Posted on Dec 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

F-163 Top Speed Helicopter will not take flight


Likely defective unit and needs a warrantee replacement.

Apr 03, 2015 | Dolls, Playsets & Toy Figures

1 Answer

My falcon v11 the blads is spinning but will not fly


my falcon v11 wont fly it just spins around on the platform

Dec 25, 2011 | Dolls, Playsets & Toy Figures

3 Answers

We have lost our instruction manuals for our rc heicopters. is the small tail propellar supposed to spin? we can't get them to liftoff the main propellars seem to be working fine.


Sadly, Bob is incorrect here. In a coaxial helicopter, the main rotors spin in opposite directions, equalizing the centrifugal force and allowing the craft to hover without spinning, fine-tuned by the adjustment of the trim control. The counter-rotating main blades and internal gyroscopes provide a stable hover, while the tail rotor serves only to push the rear of the chopper up or down, providing the forward/backward thrust. If you are not moving the right joystick, you tail rotor should be stationary, or perhaps moving lazily from the wash of the main rotors. Sounds like a charging issue. What type of charger are you using? Also, Li/Po batteries are not meant to be fully discharged. Fully draining a Li/Po too many times, ESPECIALLY when they are new, will ruin them. Luckily the batteries on an 032 are easily replaceable. Available on Amazon and many other online retailers, and replaced in about 1 minute with only a small screwdriver. With a new Li/Po, charge them FULLY with the correct charger, and always stop the flight as soon as you are having to give it full power to maintain altitude. Also CRUCIAL is you MUST MUST MUST let the battery rest and cool for after a flight, wait a good 10 minutes BEFORE you connect the heli to the charger, and another 10 minute cool down after charging before you fly.
Hope this helps
r

Aug 19, 2011 | SYMA Toys industrial Syma S032 Ready to...

1 Answer

I bought an A-10 air hog and it does not fly correctly, is there a solution?


There is a trim button on the remote or the air hog which helps to straighten out the flight if it is constantly veering off to the left or right(same direction every time).I had one though and was so disappointed that I returned it the next day.Greg

Mar 07, 2011 | Air Hogs Dolls, Playsets & Toy Figures

1 Answer

My air hogs hawk eye will not fly.what do i do?


what do you mean by it wont fly???
do the blades not spin?
does it spin rapidly in circles?
or is it just real hard to fly???

Dec 26, 2010 | Microsoft Dolls, Playsets & Toy Figures

1 Answer

Does the rc jumbo dragon fly helicopter fly forward or just up and down? Any help would be greatly appreciated. dave


This is a two channel Dave, meaning that the radio is only capable of up or down, or to spin the tail left or right. You will get forward momentum out of it because the design of parts like the removable cockpit housing, or the weight of the battery pack way out front give it "ballast" for forward momentum.

This is very similar to the way the small indoor models work. You will need to get the copter trimmed out to see this happen. Keys to stable flight are to stay at an altitude that you prescribe,

Dec 19, 2010 | Jumbo RC JUMBO HELICOPTER

1 Answer

MY CESSNA IS NOT TAKING OFF. IT ALWAYS GOES TO HIT THE GROUND, I SPENT A LOT OF MONEY AND NERVER SUCCEDED WHEN TRY TO FLY. COULD IT BE A PROPELLER PROBLEM?


Check the flight controls. Does the elevator works? if it does. then problem is on thrust. check the propeller speed, does it have enough power? Don't forget to check on the powerplant (battery or engine). But judging from your story, it is the flight control problem. cheers.

Oct 24, 2010 | RC Cessna 747 Airplane 4 Channel Electric...

1 Answer

How do i fly my spin master air hog rc helicopter all it does is go in circles


If its a Reflex twin rotor Heli use the trim wheel on top to counteract the spin and at least stabilize the craft at hover. Then use the right/left froward backward fans to control flight, (right joystick on the controller). These fans are not very powerful so don't expect alot from them other than turning the craft right left and reverse. Seems there is too much down draft from the rotors to effectively move the Heli forward. Not a real good design. The Sharpshooter is easier to fly but uses the batteries in the controller as a charger so they don't last real long.

Feb 05, 2010 | Spinmaster Air Hogs RC Reflex Micro...

3 Answers

Heli max hicro helicopter just keeps spinning in circles


Spinning is caused by one of the main propellers rotating faster than the other. If both propellers are secured tightly to their drive shafts, the spin control knob on the remote control can be used to stop the spin. However, if one prop is slipping with respect to the other, the spin control knob will not fix the problem.
I've found that the set screws holding the propellers to the drive shafts tend to loosen after a while. If one prop is a bit loose and the other is tight, the relative slippage will cause the helicopter to spin.
To check, turn off helicopter power and manually rotate each propeller separately, watching the nylon gears in the body. If the propeller is moving and its drive shaft gear isn't, the propeller is slipping because its set screws are not applying enough pressure on the propeller's drive shaft.
Carefully tighten the set screw and the problem should be fixed. DON'T OVERTIGHTEN, or the plastic threads for the set screw will be stripped and the propeller assembly will be ruined.

Apr 10, 2009 | Max Heli- Axe CX Micro Electric Rc Mini...

1 Answer

What are the control functions for the ESky 4 Ch Simulator?


To download the European version FMS flight sim go to this site http://n.ethz.ch/student/mmoeller/fms/index_e.html with Windows XP and earlier it with work fine. But you will need add the "d3drm.dll" file your your computer if you are using Vista. Go to http://www.driverskit.net/dll/get/494.html to download the file. Then put the d3drm.dll file in your C:\Windows\System32 folder on your computer. It wont work until you do this. Good luck.

Dec 28, 2008 | E Sky Flight Simulator Training Kit

Not finding what you are looking for?
Air Hogs Glow In Dark Havoc Stinger Rc  Helicopter Logo

756 people viewed this question

Ask a Question

Usually answered in minutes!

Top Air Hogs Dolls, Playsets & Toy Figures Experts

Stephan Reichert
Stephan Reichert

Level 2 Expert

194 Answers

freddyfox

Level 2 Expert

236 Answers

kakima

Level 3 Expert

96610 Answers

Are you an Air Hogs Doll, Playset and Toy Figure Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...