Question about Car Audio & Video

1 Answer

Receiver Turned Off Won't Turn On

I just installed a Pioneer DEH-P3000IB in a Jeep. It worked fine until I turned the volume up. The receiver turned off and won't turn on. Any ideas?

Posted by on

  • David Robinson Dec 30, 2008

    Thans lil fatty 8! I used to be a professional and checked all of the fuses and coctions with an ohm meter. All checked out. I then connected then connected the yellow and red together and then connected them to the battery and the receiver works. Connected them back to the switch and battery respectively and nothing. Any ideas? Thanks for your help!

  • David Robinson Dec 30, 2008

    Well I fixed it. It seems from my old tech buddies that if you put additional fuses in line with the unit for extra protection, as I did, they have to be at least the same amp rating or higher than the decks on board fuse. A lower amp fuse can cause an impedance problem in the voltage regulator in the deck. Thanks for your help!

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 44 Answers

Something had to be hooked up incorrectly.... make sure that all wires are still connected.... make sure they are tightly together.... wires can slip out very easily unless they are soldered together.... if all else fails, it may cost a little more... but if you get it done professionally, it is worth it... make sure that none of the different colored wires touched it. Also... check the fuse in the back of the cd player.... that can also be the issue. :D hope all works well for you.... stereo equipment is not cheap by any means.... Please rate answer well :D .. and good luck!

Posted on Dec 30, 2008

  • 1 more comment 
  • lil_fatty_8
    lil_fatty_8 Dec 30, 2008

    Thanks for the rating! :D sometimes these things just happen with the reception, like with alpine, their cva series have this common problem... Have you tried replacing the antenna with maybe a billet antenna? You can get them for about 30 bucks. They get better reception then most antennas, and you can also buy low-profile billet antennas as well. Let me know if you have any other questions. :D as i said, always here to help!

  • lil_fatty_8
    lil_fatty_8 Dec 30, 2008

    Please disregard the statement i made, i accidentally made a pose under the wrong tab, my mistake. As far as this goes... lets see... i know that most cd players, if they start to overheat, can go into protect mode... have you tested this cd player in a different vehicle? I think that would be a great way do get a better look as to the issue.

  • lil_fatty_8
    lil_fatty_8 Dec 30, 2008

    No Problem whatsoever! I am so glad that things worked for you!.... fixing the issue is always better than having to replace it!... Congrats :D ! if you have anymore questions for me... just give me a yell :D i know it's early, but HAPPY NEW YEARS!

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Pioneer Model: DEH-P8400BH


Press and hold the source button until the CD Receiver turns off. Press and hold the center of the volume knob top bring up the settings menu rotate the volume knob until Clear memory is displayed and then press the center of the volume knob Clear memory YES will be displayed, press the center of the volume knob to confirm. The display will change from Clearing to Cleared

Aug 07, 2012 | Pioneer Deh-p8400bh Cd/mp3/ Receiver W/...

1 Answer

How do I set the clock on my Pioneer DEH-P6200 cd receiver?


With the vehicle on, turn OFF the radio. Next, Press the Volume and hold the VOLUME knob. You should see LANGUAGE on the display. Scroll the VOLUME knob until you see CLOCK SET. Pres the VOLUME knob and the HOUR will start flashing. Scroll the VOLUME knob to set the hour then Press it to set the Minutes. When you're finished. Turn off the radio, then turn it back on. When the radio is in use, the Radio Station will scroll on the display, then the Artist information, then after a few seconds (20-30), the Clock will display.

Jan 14, 2011 | Pioneer DEH-P6200 CD Player

1 Answer

HOW SET TIME TO PIONEER DEH 3450?


turn the unit off. hold the audio/function button until display changes. turn volume knob until clock is displayed. press up/down to change hour then right/left to go to minute then up/down to change. press audio/function to exit. turn back on.

Jun 18, 2010 | Pioneer DEH-P2900MP CD Receiver...

2 Answers

How to set the clock on my pioneer deh p7000bt


with the unit on

press and hold the source button until then unit turns off ( or it my go into demo, which is fine)

then press and hold in the volume knob until a menu is displayed, scroll through there until you find the clock.

once set, you can push the source again to turn it back on

hope this helps

Aug 25, 2009 | Pioneer DEH-P7000BT Car CD/ MP3 Player

1 Answer

Need to know what connectors to buy to install my pioneer audio?


You can usually purchase a wiring harness for your vehicle to ease the connection to factory wiring. Two examples would be here:
Toyota Into Car Harness
Toyota Into Radio Harness

Feb 01, 2009 | Pioneer DEH-P3000IB Connect an iPod nano...

1 Answer

Pioneer DEH-P3000IB operations manual


How to set the clock on the DEHP3000IB?

Clock adjustment is performed in the "Initial Settings" menu. Please follow the instructions below to access time setting.

Press & Hold [OFF] (power/source button)
Pres & Hold [Muti-Control] (big button that controls volume) until "Clock Set" Appears
Turn [Muti-Control] to choose setting
Press [Muti-Control] to enter setting


Time Setting:
Press [Muti-Control] to select time setting mode
Press [Muti-Control] to select time segment. Each press will select one segment of clock
Turn [Muti-Control], or click up/down to adjust time segment.

Mar 16, 2008 | Car Audio & Video

1 Answer

Cant change the time


I don't have the manual, but I can tell you how to set the clock. This was a doozy to find out exactly how to do this! This technique probably will work with most other Pioneer receivers too.

Either start your car or turn the ignition key to the ACC position (so that the radio is receiving power). With the radio/CD turned off, press and hold the function button (the one in the upper right hand corner) for about 5 seconds, the hours on the clock should start to blink. Use the volume +/- buttons to change the hour, use the track up/down buttons to switch from hour to minutes. Press the power button to get the new time to set.

Jan 17, 2008 | Pioneer DEH-17 CD Receiver

1 Answer

DEH 245 Lights


Try Turning the Power off holding down the clock button till the clock display flashes then use the volume and tuner keys to set the time.

Dec 17, 2007 | Pioneer DEH-245 CD Changer

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4807 Answers

yadayada
yadayada

Level 3 Expert

70347 Answers

The Knight
The Knight

Level 3 Expert

72620 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...