Question about Kenmore 16919 Built-in Dishwasher

1 Answer

Kenmore 74362 My model# is 665.74362400 this unit is only just over one year old. My problem is it shut down and the quick rinse light started blinking. I have tried some of the button-reset procedures that were on some other responses but to no avell I even left it unplugged for a while. Any impute would be appreciated.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 413 Answers
Re: Kenmore 74362

The blinking buttons indicate the buttons are bad. The console will have to be replaced.

Posted on Jun 02, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Kenmore Elite 665.15929001 Dishwasher, flashing Sani-Rinse light, won't start

Kenmore is **** with a double PP go buy a Maytag or GE and throw it threw the appliance dept like the Discount tire guy did on TV. I have asked the same question on 4 different blog's and no answer. The question to where they were actually built is unavailable. They only warranty products for 1 year and their disclaimer's add up to when you walk out the door. They are just JUNK! sorry I do not know the answer, first you will pay the repair man then end up buying a new one anyway. Same as me..Peace!

Nov 14, 2012 | Dishwashers

1 Answer

My Kenmore dishwasher starts to fill and then stops

I've got the same dishwasher....mine is 2 years old and used only 3 times a week and now the motor is burnt out. I understand that this unit is a Frigidaire and is one of the worst ..quality speaking. I guess that why they only provide an one year warranty. Unfortunately, we got a LEMON

Oct 04, 2009 | Kenmore Dishwashers

1 Answer

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) /...

Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails to fix the problem give me the make and model # of the dishwasher, this can normally be found just inside the door.

Jun 22, 2009 | Dishwashers

1 Answer

Kenmore dishwasher 16764 Quick Rinse Light won't go off

you can try reseating the ribbon cable on the board however i strongly believe you have a stuck key and the key panel will need to be replaced.

Feb 02, 2009 | Kenmore 16764 Dishwasher

1 Answer

Kenmore 74362

I had the same issue and you will never beleive the solution.
Steps to follow:
1) run one full cycle with no dishes or soap
2) run one full cycle with a dishwasher cleaner like Jetdry
3) run one full cycle with a gallon of white vinager
4) never put soap in the extra in and only fill the main soap bin half way.

should work fine from here on out, but never fill main bin more then half way when you do dishes. also run the hot water in the sink until the water is very hot before starting the dish washer.

Dec 19, 2008 | Dishwashers

1 Answer

Blinking quick rinse and lock on lights

Try holding down the "lock" button.It may be the way to unlock the problem.

May 26, 2008 | Kenmore 16602 / 16604 / 16609 Built-in...

2 Answers

My Kenmore diswasher gets stuck between the quick rinse and drying cycle

I am having the same issue as described above. I think it is either the timer, thermostat (temp assure), or thermostat (temp boost) that needs replacing. The dial gets stucks in both the wash temp boost cycle and rinse temp boost cycle. However, I don't have a picture of the temp assure or boost part. Does anyone know how to fix this? Thanks. -Bill

Aug 31, 2006 | Kenmore 16602 / 16604 / 16609 Built-in...

Not finding what you are looking for?
Kenmore 16919 Built-in Dishwasher Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dishwashers Experts

Fred Sops

Level 2 Expert

271 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Raisin Brann

Level 1 Expert

28 Answers

Are you a Kenmore Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides