Question about Maytag Performa PAV2200

1 Answer

Pavt454 will not stay balanced.in spin cycle.any kind of load

Starts spinning and starts banging. yes load is reset

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Your machine has a "snubber" on it. part number 21002026. it sounds like the snubber (clear/white plastic ring) is worn out. take the front panel off the machine and look at the base. you will prob see white powder down there. if not, then you will see oil. if you see oil, your transmission is leaking. if you see the white powder, then the snubber is worn out. the problem is that you need to remove the brake to get to the snubber. DO NOT TRY THIS YORSELF if you do not have the propper tools. THE BRAKE IS UNDER ALOT OF PRESSURE. you will get seriously hurt if you do not have the correct tools to do this job.

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My washer goes into spin cycle byitself and when washing,if u r in spin cycle it sets for 14 mins thats good 4 mins into spin all knob lights start flashing and the screen says uL


One thing to understand is that this is a difficult problem to pin down and may end up requiring the control board to be replaced.

The UL or unbalanced load error is displayed when the control board senses an out of balanced load.

You don't indicate if the washer is actually out of balanced or not when the code appears but the description of banging and shaking would indicate it is out of balanced.

If the washer consistently bangs and shakes in spin then I's suggest you remove the spin basket and check under it for obstructions that might prevent the washer from spinning smoothly.

Jan 23, 2011 | Washing Machines

1 Answer

Maytag HAV4657EWW tub bangs during spin


This washing machine has self-leveling rear legs. Tilt the machine up on the front legs and you'll hear the back legs drop down to re-level itself. Center the basket and restart.

Mar 10, 2009 | Maytag MAT13MN Top Load Washer

1 Answer

Loud banging during spin cycle


please balance your washer and use smaller loads

Mar 18, 2008 | Kenmore 43052 Front Load Washer

1 Answer

Thumping and banging


make sure all shipping pins are out the tub should move all around from side to side if it level still bangs its eather the balance ring top basket are there 3 slides on a plate above the motor just put some silacone oil on tham move around

Feb 09, 2008 | Kenmore 24032\24036 Top Load Washer

Not finding what you are looking for?
Washing Machines Logo

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Al Clark

Level 2 Expert

290 Answers

Todd Marr
Todd Marr

Level 2 Expert

77 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...