New humidifier motor spinning wrong direction

Humidifier Fan Not Working - Repair Parts - RepairClinic.com

www.repairclinic.com/RepairHelp/...Fix...Humidifier/...---/Humidifier-fa...

Most Frequent Causes for Humidifier fan not working. For the most ... If the fan blade does not spin freely, replace the blower motor. If the fan blade spins freely, ...

How to Fix a Humidifier ' HomeTips

www.hometips.com/repair-fix/humidifier-doesnt-work.html

Aug 14, 2014 - Repair humidifier problems yourself with this expert, step-by-step ...6Lubricate the fan motor bearings with a couple of drops of light oil if the ...

Troubleshoot and Repair a furnace mounted Humidifier

www.instructables.com/.../Troubleshoot-and-Repair-a-furna...

InstructablesThis instructable will explain how to diagnose and, hopefully, repair a broken ... to flow through the water panel of the humidifier and the humidifier fan turns on. .... drain line was dry, GFI was not tripped, and the fan sounded like it was going so I ... Arduino · Intel IoT · Indoor Gardening · Lighting · Sewing · Parties · Star Wars.

Check to see if there is 24 volts at the transformer when the blower motor kicks on, if not the transformer will need to be replaced. If you do have 24 volts then work you way from the transformer toward the solenoid and see where the voltage stops, could be the humidistat.

Is that a Honeywell HE365?

Like to help, but I have a similar? problem. My brand new motor turns, but gets hung up and clicks. That's why I bought a new one in the first place. Now it's hot. Tried to jiggle, make sure there is enough room for the wheel to rotate. Seems to be sufficient space. Why won't the wheel turn?
It's almost like the water weighs too much and holds it the wheel in place and the gears aren't strong enough to turn it.

The saddle valve that controls the water is only to be used as an "on" or "off" control. It is not recommended as a throttle valve since it can leak if it is not placed in the full open or fully closed setting

MAKE SURE YOU HAVE TURNED THE WATER VALVE ON.

your water inlit float is blocked or, out of adjustment

Put some lubricant, oil, WD40, etc. on shaft of fan. Spin the fan with your finger and work the oil into the shaft until the fan spins freely again. Reassemble and problem will be gone for 2-3 weeks. Repeat again until you want to replace the fan motor.

These humidifiers need to be cleaned inside. They become clogged from minerals in the water.

Loosen the brass fitting where it connects to the soleniod valve. If water comes out your saddle valve is ok. Carefully retighten this fitting. With the humidifier turned on loosen the first fitting down stream from the valve see if water comes out. if it does turn the humidifier off and see if it stops, it should. That will tell you the the valve is ok then, just clean the filter and the oriface. if it does not turn on and off check the wiring. if ok replace the valve.
Good luck