1. I got Avr 220 (Harmon Kardon) reciever.My Left Channel is not working. I connected the speaker to other channels and tested +ve. However this left channel produces no sound under test or play mode.2. Also my Subwoofer MSW-1 (infinity Modulus) is not powering up.I have lost its original power cable which was 3A 60Hz 120V without ground. Now I am using 15A STD Power cable and it does not power up.It happened before, but it came back on its own.
I got the answer for No-1.
The balance was turned on the Right Channel. That is why Left Channel was not working during the Channel test.
For Channel test the Balance should be in the middle so that both Right and Left Would be heard.
I am working on my Subwoofer Isuue.
I opened the Back Panel and Yet I could ot figure out any issues.
I will open the front panel and see if any connection is loose.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Usually, it's the "stereo-audio-output" from your amplifier that goes to the sub-woofer, and then outputs from the sub-woofer to the left/right speakers. Or, if your amplifier has a separate output labelled "sub-out", then your connect your sub-woofer to that mono-channel output.
You may be trying to play a Blu Ray movie with only a 2 speaker setup. If you do that, you won`t be able to hear the voices because the Blu Ray player is sending just the left and right audio channels and not sending the center channel because there is no speaker for it. If you only have 2 speakers, then check your manual for the option to change that 5.1 channel audio stream into a 2 channel so the voices will show up in the left and right speakers.
Yes, I can help you. Your DVD player should have output connectors in the back of it to plug your amplifier or receiver into. If you have a Stereo system (no surround sound speakers, or front center speaker) connect the DVD Audio Cables on the back of the DVD player to the STEREO Output Jacks. If it is connected to the Left Front and Right Front jacks of the "Surround Sound" output jacks instead of Stereo is that the dialog on is sent to the CENTER channel output. If you have no center channel speaker you will not hear it. If you have a surround sound system with two speakers in front and two speaker in back. Then you need to make a change in the Receiver Setup (Which may be set up for 3 speakers in front) so that it is set up for 2 speakers in front. The last thing my simply be that you have a center channel front speaker that is not completely connected because of a wire falling off, etc. Hope this helps, Best, Mark
If your TV has no input selector but has a video input, the TV probably "hides" the video input between the lowest channel on the tuner and the highest channel. That means if your tuner goes from channel 2 to channel 119, the video input will be between 119 and 2. The best way to see if this is the case is to slect channel 2 and then use the up/down channel selector to go down and see if you find the video input. Let me know if this works!
Sir the home cinema system comes up with diffrent ics for all the speakers for all the speakers foreg if u have 5 speakers in it it has single ics for each one of them so i think u can have a chk with the amplifier of the home cinema may be the center spker ic is defective.............