Question about Boston Acoustics VR950 Main / Stereo Speaker

1 Answer

Static sound when red light blinks

I have the VR960 boston acoustic home theatre speakes and it crackels sometimes, they do have there own amps attached on the botton , the red light on the botton flickers but when its solid its ok. can u fix it?

Posted by on

  • Krauty9 Jan 06, 2009

    I have the same problem. I have them hooked up to a home theater set up and if the volume is too low on the TV, they crackle until the volume is turned up enough to make the red LED lights solid...I always seem to have the crackle with just one of the speakers. I am at a loss why it happens.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It might be a loose connection. Do you obly get the crackling when the red light flickers?

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Home subwoofer no sound


always 1 speaker per amp output!!! and between red and black only. You can send any signal into a subwoofer. Hi frequencies will be quiet but it's safe. switch a normal speaker for the sub and listen, you should hear a muffled sound. Look for the sub output on the amp... do you need to switch on the sub manually somewhere?

Sep 02, 2014 | Boston Acoustics Speakers & Subwoofers

1 Answer

Boston Acoustics CS26 Speakers sound cuts out for over a second at higher volumes tested using two different amplifiers same problem. Does not seem to be related to amp distortion:clipping protectio


It sounds like the speaker cones(if that is what they have) get hung up against the back of the case. No vibration=no sound. Check to see that there is no hum adding to the pressure on the speakers. Check to see that the speakers are hooked to the correct impedence output of the amplifier. Also, wire length affects impedence and shortening the wires might help.

Jan 22, 2013 | Boston Acoustics CS26 Speaker

1 Answer

Acoustic reaserch subwoofer dont have any sound


If this is a powered sub then it's most likely the internal amp inside it that has failed. It's more than likely the part that works the hardest on the board. IE the main amp semicoductor.

Dec 19, 2012 | Boston Acoustics Speakers & Subwoofers

1 Answer

Red status light will not go off or change on Boston A TVee model 2 soundbar.


I am also having the same problem. It was working fine until we moved. Plugged it in at the new house and nothing but a red light. Sub is green though.

Jul 10, 2012 | Boston Acoustics TVee Model Two TV...

1 Answer

Programming Sound bar to remote


201-762-2100 I called them and they were very responsive.

Jan 16, 2012 | Boston Acoustics Speakers & Subwoofers

1 Answer

Boston Acoustics VR 950 speaker (tweeters) have static when playing music with a lot of piano. Clean as a whistle (no problems) with acoustic (guitar), though. Are the tweeters blown, or is there...


Don't blame the speakers just yet. Check your PC's audio controls to make sure it's not modifying anything and that your speakers are defined as speakers, not headphones.

Try running UNripped music to them. Solo piano is a difficult signal to reproduce.

Nice amp, huh? I have one plus some Cubes.

Feb 20, 2011 | Boston Acoustics VR950 Main / Stereo...

1 Answer

All static from the sound bar. adjustments don't help. tried different cables - that didn't help. System is not usable at this time.


The manual...

http://www.retrevo.com/search?q=Boston+Acoustics+TVee+Model+Two

Page 7

Distorted sound from the Soundbar.

Change the Trim Level switch setting to a higher number.
Check the signal source to be sure the distortion is not originating there. <<<<<<<<<

The woofer seems to have interference with its wireless signal.

Try changing settings of the Wireless ID switches on both the soundbar and bass unit. <<<<<<<<
The bass unit could be too far from the soundbar to get a good signal. Try moving it closer.

What is the source device that results in static? How is it connected?

Feb 08, 2011 | Boston Acoustics TVee Model Two TV...

2 Answers

Boston Acoustics VR960 Crackle


I just finished repairing one of my VR960 units with a similar problem. My problem was that the sub would crackle no matter what input level. After changing a few of the active components, I finally discovered it to be a capacitor which was faulty. Anyway, I replaced the three 100uf 25V capacitors on the main board and all was well.

Good Luck.

Jul 07, 2009 | Boston Acoustics VR950 Main / Stereo...

Not finding what you are looking for?
Boston Acoustics VR950 Main / Stereo Speaker Logo

492 people viewed this question

Ask a Question

Usually answered in minutes!

Top Boston Acoustics Speakers & Subwoofers Experts

 Grubhead
Grubhead

Level 3 Expert

4593 Answers

The Knight
The Knight

Level 3 Expert

68386 Answers

Steve

Level 3 Expert

3287 Answers

Are you a Boston Acoustics Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...