Question about Sony Xplod XM-554ZR Car Audio Amplifier

1 Answer

How do i set/adjust the clock for my Sony Xplod car stereo?

100dB+
changer control CDX-GT31W
Drives - s

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 328 Answers

Http://audio.manualsonline.com/manuals/mfg/sony/cdxgt310_cdxgt31w_1.html
click on get manual......the clock set instructions are on page 5
hope this helps.................Good luck!

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am confused by the yellow 12v positive wire if red & black feeds off the battery where does yellow go


Yellow is normally an accessory connection and is switched by the ignition. It is off when the ignition is off and only powered when the ignition is on.

Feb 06, 2015 | Sony Cdx-gt29 Cd/mp3/wma Green...

1 Answer

Sony CDX-GT44U doesn't start. After switching off


car running or not? if it works with the car off then I would check the alternator, your car will require more power from your already low battery causing your radio to not play. If it won't start either way check all of the wiring going to it including your speakers. Could be loose or shorted wires. Could also be the switch on the unit. only way to know is to take it apart and test the switch. If all else fails then have it looked at.

Aug 19, 2013 | Sony Cdx-gt44u Cd Mp3 Car Stereo Player...

1 Answer

Amp comes on running 2 12" 450 watt pioneer subs, volume only seems to be about half output, with speakers bridged


This could be the reason. If you look at the specs for this amp you will see that the continuous power out is rated for 380W bridged. The speakers rated at 450W should be able to handle close to 315W continuous. Now if you split these numbers being you have bridged these speakers, you drive each one up to about 190W continuous. The speakers are being driven approximately by 60% of the rated capability. I personally like to keep it right where you got it, not exceeding 80% of the speakers rated capacity.

Here are the specs for the AMP:
  • Specifications
  • Peak Music Power 760 Watts
  • Number of Channels 2
  • Load Impedance Capability 2~8 Ohm (Stereo), 4~8 Ohm (Bridged)
  • Continuous Power (4 ohm) 125W x 2
  • Continuous Power (2 ohm) 190W x 2
  • Continuous Power Bridged (4 ohm) 380W x 1
  • Frequency Response 10Hz ~ 50kHz
  • Total Harmonic Distortion 0.008%
  • Signal-to-Noise Ratio 100dB
  • Dimensions 12" x 2-3/8" x 12-3/4"
  • Features
  • Bridgeable
  • Channel # Capability 1/2/3
  • PWM Regulated MOSFET Power Supply
  • Screw-Type Speaker Terminals
  • Balanced Isolator Input Circuit
  • RCA Inputs 2 Channel
  • Input Level Control Hi-Volt (200mV ~ 6.5v)
  • Built-in Crossover Selectable LPF (80Hz, -12dB/Oct.)
  • Aug 06, 2010 | Pioneer GM-5000T Car Audio Amplifier

    1 Answer

    Does any one have the specs for a solid audio F2500D amplifier?


    Power Output
    RMS @ 4 Ohm: 700W x 1 Ch.
    RMS @ 2 Ohm: 1300W x 1 Ch.
    RMS @ 1 Ohm: 2500W x 1 Ch.
    RMS @ 1 Ohm: 4000W x 1 Ch @18v
    Signal to Noise Ratio: >100dB
    THD (IHF-A): 0.2%
    Input Sensitivity: 0.15V – 5V
    Input Impedance: 47KOhm
    Slew Rate: 10V/USec
    Damping Factor: 300 @ 4 Ohm
    Fuse Rating: EXTERNAL 200A Fuse
    Dimensions (in mm):
    Width: 240mm
    Height: 61mm
    Length: 570mm Features
    MOSFET Power Supply Amplifier.
    Double Sided Through Hole Epoxy PCB.
    Gold-plated Brass Set Screw Terminals.
    24dB/Oct. Crossover - Variable Low Pass Crossover (40Hz ~ 200Hz)
    Variable 24dB/Oct. Subsonic Filter 10Hz ~ 70Hz
    Variable Phase Shift
    5 Way Protections
    Daisy Chain Through Output RCA
    Bass Remote Control
    Power/Protection LED
    1 Ohm Stable Circuits
    Soft Start/Output Relay
    18V Operation
    Parallel Operation

    Nov 13, 2009 | Car Amplifiers

    1 Answer

    Sony cdx-gt200 no power


    its knackered either send it in for repair or buy another amp at wholesale cost here:
    www.godspeedaudioheaven.com

    Dec 09, 2008 | Sony Xplod XM-554ZR Car Audio Amplifier

    1 Answer

    Amp a2801q


    Audiobahn A2801Q
    Product Description:
    Class A/B MOSFET Circuitry
    200 watts x 2 @ 4 ohms stereo
    280 watts x 2 @ 2 ohms stereo
    560 watts x 1 @ 4 ohms mono

    Volt Meter With Blue Illumination
    PWM MOSFET Power Supply
    Double Sided Glass Epoxy Circuit Board
    THD: 0.02%
    S/N Ratio: >100dB
    Frequency Response: 10Hz - 40KHz (+/- 1dB)
    Variable 18dB Hi-pass Crossover: 90Hz - 750Hz
    Variable 18dB Low-pass Crossover: 30Hz To 120Hz
    Bass boost @ 45Hz: 0/18dB
    Subsonic Filter: 20Hz to 50Hz
    RCA Throughput Connections
    3-way Protection Circuitry: Thermal, Short Circuit and Overload
    Cooling Fan
    Cobalt Blue Illumination
    High gloss Chrome Plated Finish
    Nickel Plated Block Terminals
    Dimensions: 2"(H) x 12.75"(W) x 15.5(D)
    1-year warranty

    Jan 02, 2008 | AudioBahn A2801Q Car Audio Amplifier

    Not finding what you are looking for?
    Sony Xplod XM-554ZR Car Audio Amplifier Logo

    4,238 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Sony Car Amplifiers Experts

    Tygh Duval
    Tygh Duval

    Level 2 Expert

    290 Answers

    Donald DCruz
    Donald DCruz

    Level 3 Expert

    17129 Answers

    yadayada
    yadayada

    Level 3 Expert

    61249 Answers

    Are you a Sony Car Amplifier Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...