Question about Supersonic SC-999TDVD 13 in. TV/DVD Combo

1 Answer

TV in standby mode

Have a supersonic 13 in. ac/dc color TV tried all buttons on tv plus remote and can not get tv off standby mode also tried 100v plus 12 volt - any suggestions thanks Irv

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,070 Answers
Re: TV in standby mode

Hi iducher the tv power supply is faulty have a tech repair your tv.good luck

Posted on Apr 26, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I need the remote code for a supersonic combo tv

Four digit universal remote code for Supersonic TV/DVD combo is:
Direct Code Entry
  1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
  2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
  3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
  4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand

Jul 05, 2011 | Supersonic FC2025 9 in. TV/DVD Combo

1 Answer

My tv auomatic off after 1 mi

1]...Please check that the sleep timer function is not set;

2]...Some tv's have a count-down timer & switch off if there is no signal input, either from the tv aerial, or av input;

Please check that the aerial is plugged in to the correct socket on the rear of the tv; test the aerial in another tv, to make sure it is working ok.

3]...It could be a problem with the remote/teletext panel?

for example, switching unexpectedly to standby, or changing channels unexpectedly?

4]...It could be a power supply fault;

for example, switched mode power supplies (SMPS) can cause problems; this could also cause the set to switch to standby mode.


If the unit still switches off after 1 minute, even after checking the tv aerial is functioning properly, & is connected to the tv unit aerial socket ok, & the source is set to the tv aerial, then this could be indicative of an internal fault.

TV sets contain extremely high & very dangerous voltages, even after the tv has been unplugged from the ac power socket, on the wall, which could kill you!

FOR THIS REASON, & FOR YOUR SAFETY PLEASE DO NOT attempt to open or repair the tv unit yourself, unless qualified to do so - please take it to the tv repair shop;
only qualified tv engineers should attempt to carry out tv repairs.

I hope this information was helpful for you.



Oct 01, 2010 | Symphonic SC313D 13 in. TV/VCR Combo

1 Answer

Need remote codes for Supersonic tv model SC-1331

Supersonic doesn't use universal remote codes for most of their can try 0096 and a few other listed on the universal remotes, but they don't work on most of the Supersonic lineup. If you have a working remote, you can buy a universal remote that has the "learn" function and you can "teach" it. Best solution: buy a new remote from Supersonic.

May 10, 2010 | Combination Televisions

1 Answer

Where can I locate the cigarette adapter to power my 13 inch Super Son tv

Radio Shack is a good source of these type adapters. Either take in TV or the manual to help salesman find proper adapter.

Nov 23, 2009 | Supersonic SC-999TDVD 13 in. TV/DVD Combo

4 Answers

TV/DVD unit locked in Standby mode

Did you check the casing for a reset button (sometime it an itty ***** hole)
Hope this helps

Jan 25, 2009 | Bush DVD142RC 14 in. TV/DVD Combo

2 Answers


Remotes for this model are No Longer Available. A custom made remote may be available at

Oct 02, 2008 | Supersonic SC-999TDVD 13 in. TV/DVD Combo

1 Answer

Auxillary mode!

I'm sorry, but you need the original remote or a universal that will activate the input on the tv.

Dec 15, 2007 | Sansui COM312AD 13" TV/VCR Combo

2 Answers

Receiving tv programs

In the menu theres a channel set up mode. You want to switch from antenna to cable mode, then do an auto search. Then all your cable channels will come in. Your going to need the original remote to go into the correct menu. good Luck

Aug 25, 2006 | Audiovox FPE1078 7.8 in. TV/DVD Combo

Not finding what you are looking for?
Supersonic SC-999TDVD 13 in. TV/DVD Combo Logo

Related Topics:

346 people viewed this question

Ask a Question

Usually answered in minutes!

Top Supersonic Combination Televisions Experts

The Knight
The Knight

Level 3 Expert

66499 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Supersonic Combination Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides