Question about Flat Panel Televisions

1 Answer

ON & OFF

I TURN LCD TV ON AND IN ABOUT 45 SECONDS IT SHUTS OFF. I CAN CHANG CHANNELS OR ADJUST, BUT IT STILL SHUTS OFF. PLEAS HELP

Posted by on

  • Anonymous Dec 28, 2008

    there is no red light, and still just shuts off after I turn it on.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

What does the red led on the front do? sounds like a firmware issue or pcb board problem

Posted on Dec 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need fix how do i make it stop flickering


Coby lcd tv keeps flickering Flat Panel Televisions ... - Fixya

www.fixya.com > ... > lcd tv keeps flickering > Flat Panel Televisions
Coby flat panel televisions lcd tv keeps flickering related questions and answers. Ask your Coby ... Why does my Coby 40 TFTV4028 LCD TV keeps flickering.

Coby adjust air fuel mixture Flat Panel Televisions ... - Fixya

www.fixya.com > ... > adjust air fuel mixture > Flat Panel Televisions
Coby flat panel televisions adjust air fuel mixture related questions and answers. Ask your Coby ... Coby 32 in tv ... to last channel, and will stop, and will display the first channel it has got. Then we have to make adjustments on channels. ... Ad. Question about 40 TFTV4028 LCD TV. 1 Answer ... Flickering can be adjusted.

Won't turn. on red standby light changes to on but then


Jan 04, 2016 | Coby 40 TFTV4028 LCD TV

1 Answer

TV turns on for a few seconds and displays "NO SIGNAL" then shuts itself off. Can't change channels or adjust volume or accept any other command.


You are not the only one I can tell you that. I had a similar problem with my Phillips 42 in. LCD HD TV.

Here's the problem. The Power Supply Board. I opened my TV up(warranty was up of course) and found several bad capacitors. Phillips and several other companies were sold capacitors that although were highly rated failed within 5 years because of a lack of preservatives. All sorts of electronic equipment is now being effected due to these defective capacitors.
Solutions?
1. Take it in and have it fixed
2. Open it up, check the board for faulty capacitors(bulged or leaking) Buy a new Power supply board and install it.
3. Remove PSB, remove faulty capacitors and replace with compatible new ones.

Hope this helps

Dec 09, 2010 | Vizio L42HDTV 42 in. LCD Television

2 Answers

After a huge lightening storm, my tv seems to be frozen, went on this morning but will not chang channels or even turn off. I can't find a reset button Help!


Unplug the set and any peripherals that are plugged into it. Then push in the power button and hold for at least 60 seconds. This should reset it to recover from the surge effects caused by the lightning.

Sep 05, 2010 | Polaroid 1911-TLXB 19 in. LCD TV

1 Answer

My Philips LCD TV just changes channels by itself


it could be one of the buttons to change channels is jammed

Jul 13, 2010 | Philips 42PFL7422D 42 in. LCD TV

2 Answers

I turn on tv shuts off after 30-45min. red lite goes dim


It's likely that the TV will require service since your troubleshooting steps didn't resolve the problem. If your TV is smaller than 30", you may carry it in to the retailer of purchase for repairs. Otherwise, service for your TV can be obtained by calling 1-888-237-8289 in the U.S. or 1-866-237-8289 in Canada.

Nov 19, 2009 | Flat Panel Televisions

1 Answer

Hdtv-dlp has no sound or picture


this sounds like a dmd board problem. these are digital modules attached to the light engines usually. samsung, rca, hitachi, have shown similiar symptoms. some units have capacitors on the boards that can be replaced, but these are dual-layer pcb's that are tough to unsolder without proper soldering iron temperature and good small gauge solder-wick. or solder pump tool. the electolytic caps. are usually 1000uf / 10v, 330uf / 10v, or 470uf / 10v. alot of the time the capacitors will "vent" or swell-up on top which helps spot faulty component. we always increase voltage rating to 16v-25v for more reliable operation. always use 105 degrees high- temperature replacement caps.

Mar 08, 2009 | Toshiba 32HL67 32 in. LCD Television

1 Answer

Fault with my Sony LCD tv


Yesterday it was looking my lcd sony then still has me without image and leaves the green lamp chimney me of power flushedly(passionate) extinguish it i it has not wanted to ignite mas that I can do

Jan 15, 2008 | Sony KDL-26S2010 26 in. LCD Television

1 Answer

Losing picture and sound


It needs a new bulb, same thing happen with me. jut get a bulb for this model and change it. if you call sony service, it will cost you about $500.

Aug 09, 2007 | Sony KDF-E55A20 55 in. LCD Television

Not finding what you are looking for?
Flat Panel Televisions Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

68368 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...