Question about Creda W120VW Front Load Washer

1 Answer

Freezer before Rinse

After recently moving house my Creda washing machine freezes at it enters the rinse cycle and makes a low buzzing noise. When started the machine fills fine and then but freezes at the start of the rinse cycle. When I click past the rinse to the spin cycle the spin cycle works fine. This happens for all of the wash programs. There is no visible damage to the machine. I have checked that the drain tube isn't blocked and there aren't any leaks. Any suggestions?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,462 Answers
Re: Freezer before Rinse

You hav'nt said if it drains. the problem just may be that you have plumbed drain hose onto a spigot on the sink drain and spigot is blanked off

Posted on Apr 24, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Smart drive 085

the buzzing noise is the pump trying to work, but it cannot due to a blockage. unplug the washer and you can lean the washer backwards and remove the pump to unblock. the fill error is probably unrelated, and is an inlet valve issue.

Sep 25, 2013 | Fisher and Paykel (IWL12)

1 Answer

My GLTF 2940 makes a buzzing sound like a relay not pulling in all the way, during the rinse cycle. If you shut off the washer, and restart it on the rinse only cycle, it goes away.

its probably your cold water rinse only valves solenoid thats loose on the structure or the coil itself is loose,you may not hear it all the time especially during the initial wash start fill,try this, set the washer for cold water fill only on the washer,but turn off the water valves that supply water and start your machine to a wash cycle as normal,try this and see if it dry buzzes(without water),then try the same on the hot side,then with the water still off open up the machine and you can localize the buzzing noise

Mar 12, 2010 | Frigidaire GLTF2940ES Front Load Washer

1 Answer

Rinse cycle doesn't work

Your cold water valve is clogged. Most likely needs to be replaced or at least cleaned.

Feb 09, 2010 | Kenmore 22422 Top Load Washer

1 Answer

Stuck on rinse cycle

Your water valve is bad or the cold side of the valve is stopped up with sediment. Clean the water valve inlets. If that does not correct the problem, replace the water valve.

Jun 14, 2009 | Whirlpool Ultimate Care II LSQ9549L Top...

1 Answer

Kenmore HE4T washer won't rinse. Valves open to

An HF Code is a Water Inlet Problem- No or Insufficient Water Supply.

Press Pause/Cancel twice to cancel the cycle. Then, unplug the washer.

Run down the list again:
Make sure faucets are completely turned on.
Make sure the fill vavles (screens where water enter machine) aren't clogged.
Make sure the hoses aren't kinked, etc.

Plug the machine back in. Try another cycle. If the problem still occurs, You may need to replace your Water Fill Valve. Let me know if you need any further assistance.

Feb 23, 2009 | Kenmore Elite 45986 Front Load Washer

1 Answer

Washing machine not rinsing

Set your machine for warm wash warm rinse.
If it works OK.
Replace the water inlet valve.

Feb 14, 2009 | Kenmore 22422 Top Load Washer

1 Answer

Kenmore model 22432100 - it won't drain or spin

sounds to me that something is stuck in your pump check the pump if you open the pump have lots of towels on hand the machine will not spin if it does not drain

Dec 29, 2008 | Kenmore 24032\24036 Top Load Washer

1 Answer

Creda W120VW washing machine - Energy & Deep Rinse Buttons. How do they work?

I found the manual on a website which I didn't note down, but which was very useful as it had almost every washing machine manual on the planet! Now I know that the energay saving and deep rinsing buttons are activated by pressing them in. Thanks anyhow for your attempt to help!

Apr 24, 2008 | Creda W120VW Front Load Washer

1 Answer

My washer washes, but doesnt rinse...

I sounds like it needs a new timer.

Oct 08, 2007 | Washing Machines

Not finding what you are looking for?
Creda W120VW Front Load Washer Logo

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Creda Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

sonic boom...
sonic boom...

Level 3 Expert

1557 Answers

Are you a Creda Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides