Question about RCA Universal Remote Control

1 Answer

Black square in picture .....

A black square is in the middle of the picture when using the tv function only. How can I get the black square to go away? Using an RCA Universal Remote control model # 3272/3373

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

Try picture in picture button on remote?

Posted on Dec 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the remote unable to turn tv off and on?


Same thing happened to me... Was ready to purchase a new remote and decided to take remote apart first and see if it could be fixed: In battery compartment, remove small screw. With small flat precision screw driver separate the black from grey part of remote starting with the larger side of remote (do not force open anything!). Then do the same from the other side of the remote, moving slowly (without forcing) towards the middle of the remote, prying open both sides of the remote delicately. Finally, from battery side, push down on battery springs which should allow you to take remote apart completely. Remove small black rubber washer holding motherboard, allowing removal of motherboard completely.
With a dry cloth gently wipe motherboard down. Clean the rest of the remote (NOT motherboard) with warm water and soap. (After a few years, inside remote accumulates sweat and dirt ! Use paper towel to dry inside part of remote first as best as possible. Finish by blow drying thoroughly every part that was washed with soap and water. Wipe down again the motherboard removing all type of humidity and possible greasy layer that may have accumulated through the years. Put remote back together by snapping every part back in place (much easier than taking apart). Don't forget to insert black square part, black rubber washer and little screw in battery compartment. Once this is done, make sure bottom black switch of remote is pushed to desired position (TV for me). Your remote should work properly, on/off button should also work properly. Don't forget TV has 2 setting for On/off switch, one normal the other something like "power saving" which requires user to press on/off button for a few seconds. This definitely worked for me, hope this works for you :)

Jun 11, 2014 | Toshiba Ct-90275 Remote Control

1 Answer

Red led on upper left of middle circuitboard


open it and clean the c.board. However you must test it. see the picture attached. Clean the old board for colder joint.

God bless you001ef3d6-1983-4fed-95cc-91e8c679a39f.jpeg

May 23, 2013 | Olevia 42" 242-t11 1080i widescreen hdtv...

1 Answer

Picture has lines and goes black after warm up


Try unplugging for 2 mins. Or press power button for 30 seconds. Your Light in the tv might be shot.... happens every 5 or so years.
GOOD LUCK
CNBY

Jun 03, 2010 | JVC RM-C18G-1H Remote Control

1 Answer

TV screen has black square in middle- something w/the GE Universal remote programming... What?


Unhook everything and re hook it back up (or just unplug from the wall for 30 secs) and see if that helps, what kind of TV is it? Are you trying to set up a universal remote with it?

Apr 14, 2010 | Universal Remote Control GE174Universal...

1 Answer

TV has a black square box blocking out the channel


this is probably the closed captioning option, go into the menu and turn off closed captioning, its probably on text....Hopefully this helps

Jul 18, 2009 | JVC RM-C745 Remote Control

1 Answer

Remote


http://www.hifi-remote.com/ofa/codes-tv.shtml#tv

If none of the codes work then we have two other solutions:

1. Searching For Your Code

If you have tried all of the set-up codes for your brand of equipment ,or yourbrand is not listed, and you are still not able to get the unit to respond, trythe following procedure to search for your code.
If you don't find a code that works, the remote will flash four times when youreach the end of all the codes for this device type.
  1. PRESS the button for the device you want to program, (TV, VCR, CABLE, etc.), then RELEASE.
  2. PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
  3. ENTER 9-9-1 (two blinks on the remote)
  4. ALTERNATE slowly between the POWER key and the DEVICE (TV, VCR, CABLE, etc.) button until your device turns off. (On VCR, LD, and CD players use PLAY instead of POWER)
    Make sure that the remote is pointed at your device during the search, You may have to press this sequences of buttons up to 100 times to search the entire library of codes.
  5. When your device turns OFF, PRESS the SETUP button and RELEASE it to lock in the code for your device.

2. Learn the buttons from the original

Line up your original remote and the head-to-head before completing thefollowing steps.
  1. PRESS and HOLD the SETUP button until the red LED flashes twice.
  2. PRESS 9 - 7 - 5, the red LED will flash twice.
  3. PRESS the DEVICE key where you wish to learn the function. The next 3 steps must be completed within 10 seconds.
  4. PRESS the button that will receive the learned function, the LED will flash rapidly.
  5. PRESS the button on the original remote to be learned.

Now you can repeat steps 3 through 5 to learn other functions onto other keysor press and hold SETUP until the Cinema's red light flashes twice to lock inyour new feature. (If the red light does not blink twice, stop and repeat stepsthrough 6).
To test the new feature, press and release the device key in which the newfeature was learned followed by the key on which the feature was learned

More help for programming your remote can be found here:
http://www.hifi-remote.com/manuals/ofa-l.shtml?URC-7800#device

Hope that helps! Should you have any further questions,please feel free to post them here.
Television Video - DVD Audio Satellite Set Top Box Video - VCR Brand: Model (optional): clip_image001.gifclip_image001.gifWe could not find an exact match, we think this code will work. 10054 clip_image001.gifclip_image001.gifSetup Instructions
· Set the "Mode Switch" to TV.
· Press and hold the "Mute" button and the "Select" button until the visible LED blinks twice.
· Enter the 5 digit Code above.
· Try your new code and tell us how it worked!
You'll have to settle for that, use the middle power key in the tv device to power on & off the tv.


hope this may help;

Regards,
VOTIT

DON'T FORGET TO RATE;

Jul 28, 2008 | RCA Universal Remote Control

1 Answer

A black square on my tv


That when you enabled the Parental Control ON. Try to turn it off. But you need the 4 digit code do that. And if you dont know try to call 800 company number and ask how to reset the TV for factury default. Good luck Hope this may help you Pls. rate me

Aug 07, 2007 | Nikon MC-EU1 LCD Remote Control

1 Answer

Repairing color television philips


Some tv's let you select menu from the buttons on the tv,on of the buttons will say menu and the volume and channel buttos will have a double function like an arrow to the right and left and arrow up and down,they also have a buttos that says select,press menu and use the others buttos to move thru the menus until you get to the color bar,if it is at minimum adjust it so you get your color back but if it is already in the middle the tv needs to be service.Philips sells universal remote controls that are already program to work your tv being a philips and you dont have to programe it and you can also access the menu.

Oct 02, 2006 | Abt Television ABT IJETABT01 WIRELESS RF...

Not finding what you are looking for?
Remote Controls Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Remote Controls Experts

The Knight
The Knight

Level 3 Expert

68323 Answers

andy williard
andy williard

Level 2 Expert

226 Answers

Cindy Wells

Level 3 Expert

4758 Answers

Are you a RCA Remote Control Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...