Question about Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

1 Answer

Water left after finishing wash

I have a Bosch dish washer, model SHY56A05UC. It is working fine. Just when finishing wash, there is lots of water left at the bottom inside the dish washer. I think the drain pump is good because the machine is working normally. Does any body have same problem?

Thanks

Posted by on

  • chicken99 Dec 28, 2008

    same exact problem

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a Bosch Dishwasher and the E-Nr is SGS4362EU/03. The machine is approximately 4 years old, in good condition and has been working very well. Suddenly, there is water remaining after it completes a 50 degrees C wash cycle. This is also evident with the pre wash cycle and the 65 degrees wash cycle.

I have checked and cleaned the filters. I have loosened the internal pump white cover (Torx T 20 screw) and checked for any physical blockage - none. I have also checked for any drainage hose kinks - none.

I have tried a series of empty washes and the machine drains the water during the wash cycles. The dishes are also have a dull colour and show show signs of not being properly rinsed during the wash cycle.

Please assist.

Reagrds,

Brian

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lots of Dishwasher Issues- I have a Bosch dishwasher that is approximately 1 year old. For the first 6-9 months it cleaned perfect. It would wash everything off the dishes and leave them sparkling clean...


Do you have hard water? Many states have passed laws that outlawed phosphate as an ingredient in dishwasher detergent. If you have hard water, the detergents don't work very well anymore. The residue is probably hard water deposits (calcium and magnesium). Not harmful but it looks awful on your dishes. There are some new products that were designed to solve this exact problem. They are inexpensive and effective. Can't say the name or I'll get banned (again). Internet search will uncover it.

May 07, 2011 | Bosch 24 in. SHU43 Built-in Dishwasher

1 Answer

Just got a new Bosch dishwasher (forget which model). After the dishwashing cycle has ended (even long after), the dishwasher and dishes are still wet. Was this an installation problem? Thanks


Hi -
I can't see how any installation problem would cause this - if the dishes are still wet at the end of the cycle, you'll probably find the water isn't heating during the wash cycle. The dishwasher uses steam to heat the washing compartment and dry the dishes. It would appear that the dishwasher isn't heating water internally.
Even if the washer was accidentally connected to the cold water supply ** (see note), this shouldn't happen as regardless of the water supply temperature, the washer should still heat the water to the correct temperature internally.
** UK dishwashers should be connected to the cold water supply. For US installations, dishwashers are commonly connected to the hot water supply. For other locations, please consult your installation instructions.
I suggest you start a regular wash cycle and leave it to run for 10-15 minutes. Then open the door and test the temperature of the water in the base of the washer by hand. The water should be hot and there should be steam present in the washer when you open the door.
If the water is cold or only warm, the water isn't being heated internally or isn't heating to the correct temperature, in which case you should contact the retailer or Bosch Service immediately for a replacement. Do not accept an offer of repair on a brand new washer!
Additionally, do not attempt to repair the dishwasher yourself when under warrantly as this will invalidate the warranty.
Hope this helps. If you need further assistance, please let me know your location and the model number of the washer. This should be laser-etched into the top of the door if you can't find it on any of your paperwork.
Regards, BElectric

Apr 27, 2011 | Bosch 24 in. SGS45E02 / SGS45E08 Exxcel...

1 Answer

My Bosch Dishwasher is not drying my dishes now. The model number is SHE44C05UC.


Hi there,

Unfortunately, it seems that the heating element has failed. The dishwasher uses steam to heat the tub to dry the dishes. I suspect your dishes are also being washed in cold water.

To check this, please run a regular full wash cycle. Allow the washer to fill with water and run for about 10 minutes, then open the door and feel the water temperature in the bottom of the washer. If the water is cold, it's more than likely the heating element has failed.

There are other possible faults which would cause the element not to heat, but these often prevent the dishwasher from completing the cycle. If the water is cold but the dishwasher still drains the water at the end - and completes the cycle - the heating element has probably failed.

Please try this simple test for water temperature and let me know if you need further assistance.

Regards,
BElectric

Feb 18, 2011 | Bosch 24 in. SHE44C05UC Stainless Steel...

1 Answer

Bosch Dishwasher - Model SHU43C07UC --- intermitently shuts off during wash cycle -- restarts later, sometimes several hours later and then finishes cyc'e


Cold water is the only type of water that fills your tub. The machine looks like it stops because it is waiting for the water heater to heat the water in your machine to a highert temperature, enough to get your dishes clean.On that model you can't say very often that your dishes don't get clean.

Feb 16, 2010 | Bosch 24 in. SHU43 Built-in Dishwasher

1 Answer

Dishes are cloudy and residue builds up on dishes


I have a Bosch also with a similar problem. I cleaned everything that I could (lower screen in bottom of washer, etc.) and still had scum. I have hot and softened water and neither fixed it.
Here is a cheap solution. If it does not work, you are out some vinegar. I started the rinse cycle, once it was full of water, used 1 cup of white vinegar dumped it in the bottom of the washer and ran it through. 20 min. Then ran another rinse cycle to wash it down. Next load came out 5 stars! Just like new. The vinegar can be corrosive if left in there for a long time, but it breaks down a lot of the mineral build up. Very acidic. Hope it works.

Jan 03, 2010 | KitchenAid Dishwashers

1 Answer

After a complete wash the dishes were covered with a white residue


I have a Bosch also with a similar problem. I cleaned everything that I could (lower screen, etc.) and still had scum. I have hot and softened water and neither fixed it.
Here is a cheap solution. If it does not work, you are out some vinegar. I started the rinse cycle, once it was full of water, used 1 cup of white vinegar dumped it in the bottom of the washer and ran it through. 20 min. Then ran another rinse cycle to wash it down. Next load came out 5 stars! Just like new. The vinegar can be corrosive if left in there for a long time, but it breaks down a lot of the mineral build up. Very acidic. Hope it works.

Dec 21, 2009 | Bosch 24 in. SHU66C05 Stainless Steel...

1 Answer

Bosch dish washer not washing


are any lights blinking is there an error code on the disp whats the model #

Jul 01, 2009 | Dishwashers

2 Answers

Loud humming noise when dishwasher is filling up with water


your model is pretty new. just so you know your warrenty is 1 year parts and labor. 2 years on parts. it should not cost that much money.

there are two components that start before the circulation pump.(wash noise you hear)

first sounds you hear will be the drain pump. usually rattling noises if something is in it but it can make a hum noise if something is jamming the drain propeller up. which is accessible with a T20 torx driver. take the filters out and the mesh filter. and unscrew the screw in the base towards the left. pull out whatever is lodged.

the other humming sound can come from the next component that activates is the watervalve. make sure you dont have a kinked water intake line. otherwise its a bad valve. i have had to change a few of those water valves out already but not for a hum noise on your model. you have a new style water valve. when brands make new parts we get problems fast sometimes..

Feb 14, 2009 | Bosch 24 in. SHE44C02UC / SHE44C06UC /...

2 Answers

Dishes are not coming out fully clean


first if the pump is running and you can hear it washing it should clean now hot water cleans dishes not the washer the hotter the better at least 130-135 degrees modern dish washers use less water than older models so if you don't get the water as hot as you can stand it at the sink before you turn the washer on you can fill it with cold water second its important that you use jet dry and if your dishes aren't dry at the end of the cycle then on most washers you can turn the disp up for more hope that helps let me know

Dec 01, 2007 | Bosch 24 in. SHU53 Built-in Dishwasher

3 Answers

Bosch Dishwasher wont drain


have you removed the filter? if it gets clogged the dishwasher wont drain. other wise is sounds like a faulty drain pump

Nov 17, 2007 | Bosch 24 in. SHY56A05 Stainless Steel...

Not finding what you are looking for?
Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher Logo

561 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

prem mathew

Level 3 Expert

662 Answers

Are you a Bosch Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...