Question about Technics SA-EX510
I have a technics sa-ex510 reciever with jvc sxxsw6000 speakers and when the dolby surround sound is off i can hear everything just fine but when i oress it on i cant hear anything. im pretty sure all the speakers are hooked up properly i just dont know what to do. please help
SOURCE: Technics SA DA20
I have a Technics SA DA20 control receiver. I was given it by an electronics workshop and it has this same error of OVERLOAD coming into the display when switched on. I removed the plates from underneath and re-soldered as far as I could all the points along the stereo amplifier ICs and as far as access would allow. The unit then worked normally for several hours. I was very pleased, and went out shopping!. But on my return after it had been off for about an hour, the same problem has come back. But my boss at the electornics workshop thinks it it just a dry joint, or series of dry joints. The unit is complex to dismantle, so patience and care is required in taking it apart and making a note or diagram of how it comes to pieces and how to re-assemble it after the board has been re-soldered. It does not appear to be a component problem or fault with the SVI power amplifier ICs.
Posted on Jul 13, 2009
Tips for a great answer:
May 12, 2016 | Technics Audio Players & Recorders
Dec 21, 2014 | Panasonic Technics SA-G76 AV Control...
Jul 28, 2013 | Panasonic Technics SA-G76 AV Control...
Jan 10, 2010 | Technics SA-EX600
Nov 26, 2008 | Technics SA-TX50 Receiver
Apr 30, 2007 | Technics SA-DX930 Receiver
146 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: