Question about Frigidaire GLEB30T8A Electric Double Oven

Open Question

Gleb30t8csa Double Oven top will not heat over 295

Hello,
I have a gleb30t8csa Frigidaire double convection oven that is about 5 years old. Today My mother was baking and all of a sudden would not heat over 295,
Any suggestions?

Posted by on

4 Suggested Answers

  • 116 Answers

SOURCE: Double oven / convection not working

It is likely that the convection element is burned out and needs to be replaced. If all other functions are working then this is the place to start. Teh back panel inside of the oven can be removed by removing the 4 visible philips screws on it. The element should look smooth and round, if not then it needs to be replaced. Be sure to turn power off to the oven before replacing it. Remove the screws that fasten the element to the back wall and gently pull the element away from the wall an inch or so. the wires will be exposed and can be unclipped from the element do not let them fall inside of the back of the oven or you will have to remove the oven from the wall to get at the back panel. Install the new element in the reverse procedure. If the element looks good then it will have to be tested with a multimeter to verify that it is still good before proceeding to check the selector switch for burn marks.

Posted on Mar 11, 2007

  • 1314 Answers

SOURCE: installing a new frigidaire double oven

there should be some screw holes along the sides installation instructions should have come with the unit but if they did not can get them here http://www.frigidaire.com/support/ResultsPage.asp?strModel=PLEB27T9DC&User=&Search=Search

Posted on Feb 13, 2008

aborcass
  • 2651 Answers

SOURCE: Frigidaire double oven has one element not working in each oven

sounds as if perhaps there has been a thermal overload(switch) tha has gone bad, refer to part number 119 on bothe the lower and upper oven for refernce , you should have continuity trough the switches.
ftp://ftp.electrolux-na.com/ProdInfo_PDF/Lassomption/5995383394.pdf

Posted on Dec 21, 2008

ginko
  • 19396 Answers

SOURCE: how do I remove the oven door of Frigidaire Model

Hi.

You have to open the door all the way through.

Then remove the two locks from the hinges.Pull the tabs out, help yourself with a screwdriver.

Grab the door firmly on both sides, pull up the top of the door and slide it out.

Here all diagrams and parts for your appliance.

Regards.

Posted on Mar 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Frigidaire double convection wall ovens, model GLEB30T9DSA ... The top oven will not heat, both the bottom element and the broiler.....


I have the Frigidaire PLEB30S8CCA single wall oven. About 3 months ago the baking element appeared to have gone out. We replaced it, but still didn't work. We ended up sending our control board off to a company named Corecentric. They fixed the problem and returned it to us. The oven has worked perfectly ever since. I searched extensively for a new one, but no one sold them anymore. I found Corecentric on Ebay. They were able to confirm over the phone that it was more than likely a control board issue. It cost about $130. My husband was able to do it himself by taking a couple before px and using them when reassembling it.

Apr 04, 2014 | Frigidaire 30 in. Electric Gallery Series...

1 Answer

Dacro Wall oven (electric) does not heat past 345 degrees on bake or convection bake but broiler works and bottom oven works fine (for bake, convection bake and broil).


it could be the oven temp sensor rod located near the top of the inside of the oven,or possibly the bake element has a hot spot on the element and can no longer pass enough current thru this spot to correctly heat to your settings a hot spot on the element will look discolored in this area

Jul 28, 2012 | Dacor Ovens

1 Answer

Slow to heat on convection mode, bottom element not get as hot as


Check to see that the convection element is heating. If not, ohm it out, either the element is bad or it is not getting power from the control.

Jun 25, 2010 | Frigidaire 30 in. Electric Gallery Series...

1 Answer

Bake element does not work during convection cooking


Hello and welcome to Fixya.

I hadn't seen your post prior to today, so perhaps you've had a remedy presented to you already.

If you have not, reply to this post and I can recommend a few test to perform that will determine the issue with your oven.

Off the top it sounds like a possible faulty convection heating element or the K3 relay on the board is defective.

I'll watch for your reply.

Thank's,

macmarkus :)

Jun 07, 2010 | Thermador SC302T Electric Double Oven

1 Answer

How do I remove the oven door of Frigidaire Model


Hi.

You have to open the door all the way through.

Then remove the two locks from the hinges.Pull the tabs out, help yourself with a screwdriver.

Grab the door firmly on both sides, pull up the top of the door and slide it out.

Here all diagrams and parts for your appliance.

Regards.

Mar 04, 2010 | Frigidaire GLEB30T8A Electric Double Oven

1 Answer

Neff U1721 bottom oven not heating fan & light are ok


Yes it will need a new element, if the fan runs and temperature light comes on then the element is gone.

Jun 08, 2009 | Neff U1721 Double circotherm Electric Oven

1 Answer

F8 / Convection portion of top oven doesn't work


F8 Oven door lock failure Check lock relay and door switches.

Apr 02, 2009 | Frigidaire 27 in. Electric Gallery Pro...

1 Answer

Bosch convection double oven,ovens won't heat,only broilers work


If it is fan assisted then check the fan element, it is located behind a panel at the rear of the oven compartment.
Plz rate my\solution.
Thanks.

Dec 17, 2008 | Bosch Ovens

1 Answer

Installing a new frigidaire double oven


there should be some screw holes along the sides installation instructions should have come with the unit but if they did not can get them here http://www.frigidaire.com/support/ResultsPage.asp?strModel=PLEB27T9DC&User=&Search=Search

Feb 13, 2008 | Frigidaire PLEB27T9DC Electric Double Oven

1 Answer

Gaggenau oven won't heat on convection setting


this could be due to more than one cause selector switch faulty elements faulty. however this would mean both elements gone - there is one at the top and one at the bottom also worth while looking at the wiring to the convection elements. does the thermostat neon come on when convection is selected?

May 18, 2007 | Gaggenau EB294/295 Electric Double Oven

Not finding what you are looking for?
Frigidaire GLEB30T8A Electric Double Oven Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Ovens Experts

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Are you a Frigidaire Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...