· These malfunctions are concerned with faulty symptoms as they relate to software, hardware,
and communications. For remedial actions, change the board, check for cable connections,
and turn the Power Switch OFF and ON.
(6) C10]] to C13]]
C1300 1. Reset the malfunction and turn OFF and ON the Power Switch.
2. If the same malfunction persists, check the harnesses and PJs between PH
Unit and PWB-A and, if they are intact, change PH Unit or PWB-A, in that order.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Print Head failure. The print head is what has the copier LASER inside of it. Check the connection between the print head and Master board. Replace the print head fist then board, if you can find either one. The Di250F is a legacy Minolta machine now konicaminolta.
Print head failure the print head houses the LASER. Chk the connection between print head control board. replace print head first if then not that control board. CHECK all connections on the control board first also bent PIN! pull each connector one at time
On a Di250 this C1300 code means that your laser scanner motor has frozen up. This unit is a small circuit board with a motor that spins a 6 sided mirror. The laser bounces off of the mirror and writes the image onto the imaging unit. You are going to have to have a service person come out and replace the motor. The cost will depend on your location but I would estimate it to be around $400.00 for parts and labor.
Good Luck and Thank You for using Fixya.
The motor in side the print head error the print head houses a motor which scans the LASER across the drum, can't get just a motor you get the entire print head try this site if they still have them you have a legacy Minolta machine now Konica Minolta. Open close the front door to reset.