Question about Jl Audio 12W6v2 Car Subwoofer

1 Answer

REWIRE Whats the best way to rewire your JLW6V2 to 8OHMS ? I want my speakers to sound clear & to have better bass.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 15,935 Answers

Series wiring of a 4 ohm DVC subwoofer will result in an 8 ohm load.
See the following diagram.
The diagram listed has a dual 2 ohm voicecoil, netting 4 ohm, however in your case, the dual 4 ohm sub will net an 8 ohm load.

REWIRE - 34cc953.gif

Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My radio has a display and i know the speakers are working, i pulled the radio out and has a connector with a lot of wires if you press on the bundle of wires i have sound, put back in place no sound


I think the ground wire is no good, check the Black Wire.

Best way is to rewire everything, if you are not sure what to do, remove each wire and reconnect each one, use wire connectors instead of electrical tape if you could.

May 27, 2011 | Car Speakers & Subwoofers

1 Answer

How to rewire voice coil of a speaker


You cannot rewire a voice coil of a speaker unless the speaker itselfis rebuildable. If it is rebuidable, a complete reconing kit is necessary

Dec 23, 2010 | Car Speakers & Subwoofers

1 Answer

Need to rwire audio speakers in a 1999 f250 super


Try here:
http://www.the12volt.com/installbay/vehiclewiring/1/yeard/Ford.html

Apr 25, 2010 | Car Speakers & Subwoofers

1 Answer

How to mount a bandpass sub


usually you will get the best sound with the box mounted approximately 3" away from rear of trunk with speaker facing toward the rear of trunk if it is a single speaker enclosure you want to do the same just offset it to one side of the trunk corners always amplify sound however just so you know 10's are not really made for low bass they usually have more of a hard hitting pound instead of a low rumble usually 12's will give you the low bass better and it also depends on what kind of box a vented box would be best for low bass sealed box gives you tighter bass but you need more power ported is good for low bass but gets sloppy when loud and a bandpass is used for loud hard hitting bass

Feb 27, 2010 | Car Speakers & Subwoofers

1 Answer

I have a ford fiesta style 58 plate, speakers in drivers door are not working. how to do i check wiring?


Easiest way is hooking up temporarily another speaker, one that you know that works, to isolate the problem, either on the cable, or the speaker itself. Just connect it in parallel to the door´s speaker terminal, it wont hurt the head unit. If you still get no sound, make sure the head unit is not damaged for the left side. if there is sound at the headunit, you will have to rewire.

Oct 06, 2009 | Car Speakers & Subwoofers

1 Answer

Replace rear speaker 2000 es300


You need to check to see if it is an external amp or an amp that is built in with the speakers. They may be 2ohm factory speakers on that stock system, if so you may need a rewire. take a look at the rears and see if you see a small amp. Its Lexus so hopefully it will be a straight forward swap. get back to me if needed.

Jun 02, 2009 | Nakamichi SP-C622 Car Speaker

1 Answer

No sound out of subs


undo all the wires to the amp and the speakers and simply rewire em.

Feb 25, 2009 | Jl Audio 12W3 Car Subwoofer

1 Answer

My Subs blew out but I dont know why??


rewire the whole system with new wires,you could have a bad ground or wire try it first if that dont work rewire

Jan 08, 2008 | Jl Audio 12W3 Car Subwoofer

2 Answers

Car stereo installation speakers


Your old unit was a common ground unit meaning all speaker grounds as well a radio ground were the same. The new unit should NOT be connected to this wire configuration. Newer units change the potential difference of the speaker power meaning that the - wire of the unit may have negative 24v on it so IT CANNOT BE REFERENCED TO EARTH OR CHASSIS GROUND.

I would recommend rewiring the speakers to the radio for best reliability and sound quality.

Dec 31, 2007 | Jl Audio 12W3 Car Subwoofer

Not finding what you are looking for?
Jl Audio 12W6v2 Car Subwoofer Logo

Related Topics:

758 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jl Audio Car Speakers & Subwoofers Experts

Alan Desotell
Alan Desotell

Level 1 Expert

17 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Brandon Berry
Brandon Berry

Level 2 Expert

407 Answers

Are you a Jl Audio Car Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...