Question about Orion STV2763 27" TV

1 Answer

Bottom of picture is not all the way visible.

The bottom of my picture is not all the way visible. For example: the scoreboard or the weather that runs across the bottom of the screen, is not completely vissible. All the other t.v. sets in my home show it perfectly. Any suggestions? Thaks for any help!

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 68 Answers
Re: bottom of picture is not all the way visible.

You need to adjust the vertical setting on your tv set. are you a tech person? if you are just follow these instructions. turn the tv off and unplug it. take the back of the tv off. you will find the screen and the crt tube. on the tube, you will find the yoke of the screen follow the four wires coming down to the board. you will find small knobs. you will find writing next to these knobs. look for vertical phase. once you find it. now you have to plug the tv and do this live. be carefull. once you see the picture on the screen. adjust this knob till you see the bottom. good luck

Posted on Apr 21, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Picture is larger than display area

Check the aspect ratio settings you may have it set to 14:9 movie expand

Jan 30, 2010 | Samsung HL-P6163W 61" TV

1 Answer

The picture is cutting off at the top. When watching a football game I cannot see the scoreboard or time. It happens on other channels as well and is progressively getting worse.

You have a vertical deflection problem, usually bad capacitor in that circuit , if you have some knowledge of electronics you may want to look for 100 to 220mfds/35v capacitor around the vertical output i.c.otherwise you`ll need the help from a tv repairman

Nov 02, 2009 | Durabrand DWT2405 24" TV

1 Answer

Toshiba 35A44

check the verticle stage
electrolitic capacitors
and the verticle IC

Sep 04, 2008 | Toshiba 35A44 35" TV

1 Answer

Picture doesn't fit the screen

you need to adjust the VERTICAL trim pot , you have to open the TV and look for a tiny round plastic or metal button and while tv is on adjust it till you get the whole screen inside the
plastic frame, hope that it helps.

Apr 15, 2008 | Samsung TXJ2767 27" TV

2 Answers

Picture partially cropped at bottom of screen

Normallly, if the picture size button on the remote for the television does not achieve the desired affect, then, a cable box or a satelite box is where the change needs to be made.
For example:
A Motorola Cable box needs to be set up to go to a wide screen or zoom when an analog signal is detected.
Some Dish Network boxes have Size buttons on their remotes and also in their main menu.
It's difficult to determine the repair without knowing the types of the peripherals.
Hope this helps.

Dec 24, 2007 | JVC AV-27230 27" TV

1 Answer

Picture got bigger

Yes, you can adjust the picture by using your remote going to settings, or "Adjust" when your t.v. turns on and off by itself could have'ft to do with nasty weather near you, or the cord is loose and it needs to be pushed in all the way.

Nov 29, 2007 | RCA 32V550T 32" TV

2 Answers

Picture is now a thin horizontal line

now only visible in a thin horizontal line. first of all you reduce brightness to monimum. it just to protect your tv from crt demage. your problem is in horizontal output section as you have mentioned that week or so ago the right and left bottom edges of the picture began to move in like a sideways triangle filled with black so this sympton is due to hor. section problem. your flyback transformer or horizontal output might be defective. but remember check for power supply is ok from surge protector hope this will help.

Oct 07, 2007 | Hitachi 35UX80B 35" TV

2 Answers

Out of focus

How old is the set? If picture is really very blurry, Try adjusting 'focus'. You can find this conttrol generally at the rear of the set. Otherwise,. if you know solid state electronics, Check the Focus control on the FBT. It is also possible that the CTR Base is faulty. Replacing this helps.

Mar 31, 2007 | Zenith Z25X22S 25" TV

1 Answer

Corner of picture missing

There is nothing you can do ,the units has a service problem and need to be diagnose by a qualified technician,something went bad and it needs to be replaced.Be safe and call for an estimate.

Sep 17, 2006 | Emerson EWF2704 TV

Not finding what you are looking for?
Orion STV2763 27" TV Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Orion Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66644 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 2 Expert

224 Answers

Are you an Orion Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides