Question about Sony Projection Televisions

Open Question

SONY Videoscope XBR Rear Projection TV (built-in) - where find Mo

Where might I find a model number for this SONY XBR on the front of the unit or in, perhaps, in the diagnostics screens on the set?

The huge set is built-in and is a bear to disassemble the cabinetry and roll out the XBR.

Posted by on

4 Suggested Answers

Cybertech
  • 149 Answers

SOURCE: Sony Videoscope XBR TV

just need to balance the three colors red,green and blue that may help remove the front covers and look for black module that have sccree and focus controls just move a little bet left or right be carefull because you can loos the picture e-mail me for more info

Posted on Apr 08, 2008

  • 4234 Answers

SOURCE: Sony Videoscope XBR 53

This is a convergence problem. Look in the back for a couple of large black ICs attached to a heatsnik. These should be marked STKxxx. These are the convergence ICs and either have bad connections or are defective. If you can solder, try resoldering the pins on these ICs. If that fails to resolve the problem, replace the ICs. There may be other parts that need to be replaced as well. I'll look up your model to find the other parts to check. The convergence board as an assembly, I believe, is no longer available. The parts that you require are available.

Dan

Posted on Sep 18, 2008

  • 4234 Answers

SOURCE: TV has sound no picture, Sony Videoscope xbr

Please post both the exact model number (on the back) and the blink count. The standby light should be blinking a repeated pattern. That info will indicate the problem circuit and allow us to provide you with the proper parts/steps to resolve this.

Thanks,
Dan

Posted on Feb 10, 2009

  • 139 Answers

SOURCE: distorted curved picture upper and lower screen on

CONVERGENCE PROBLEMS ARE COMMON ON THIS MODEL. THIS WILL REQUIRE PARTS REPLACEMENT.

Posted on Dec 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My sony videoscope XBR tv has a pink picture and no control. Also nothing is in enlish.


the model listed is a very old set---parts may not be available----language can be selected in the menu but the pink may be a adjustment of the screens (controls) or a circuit problem.

Aug 26, 2012 | Sony KP-53XBR45 53" Rear Projection...

1 Answer

Can't turn off pip on sony XBR videoscope TV


Look on your TV remote and press the button clearly labled PIP or Picture-In-Picture and press that button over and over. It will cycle through all the PIP modes until it turns it off!

May 02, 2011 | Projection Televisions

1 Answer

HI I have a 1998 Sony Videoscope XBR 53 in. Projection TV. When you turn it on the sound is fine but sometimes the picture comes right on and sometimes it can take hours. Can anyone give me some advice....


hello well it's and old tv, my guess it could be capacitors in the power supply or even dry joints on the power supply board, it would be best to have someone with electronic experience to have a look at it

regards
shaun

Oct 06, 2010 | Sony KP-53S65 53" Rear Projection...

1 Answer

I have a universal remote and need the code for a Sony Videoscope XBR projection tv


I don't know if all codes are the same. Comcast Cable gave me a list of codes for their universal remote for their motorola cable boxes. For Sony tvs it says either 0000 or 0111. I still use all 7 of my remotes. Universals are basically only good for power and volume. I need the other remotes handy to enjoy the other functions of my system! Anyway, hope this works 4-u and that you get better use out of it than me.

Sep 01, 2009 | Sony KP-51HW40 51" Rear Projection...

1 Answer

TV has sound no picture, Sony Videoscope xbr


Please post both the exact model number (on the back) and the blink count. The standby light should be blinking a repeated pattern. That info will indicate the problem circuit and allow us to provide you with the proper parts/steps to resolve this.

Thanks,
Dan

Feb 10, 2009 | Sony KP-53XBR45 53" Rear Projection...

1 Answer

Sony Videoscope XBR 53


This is a convergence problem. Look in the back for a couple of large black ICs attached to a heatsnik. These should be marked STKxxx. These are the convergence ICs and either have bad connections or are defective. If you can solder, try resoldering the pins on these ICs. If that fails to resolve the problem, replace the ICs. There may be other parts that need to be replaced as well. I'll look up your model to find the other parts to check. The convergence board as an assembly, I believe, is no longer available. The parts that you require are available.

Dan

Sep 18, 2008 | Projection Televisions

1 Answer

Sony Videoscope XBR TV


just need to balance the three colors red,green and blue that may help remove the front covers and look for black module that have sccree and focus controls just move a little bet left or right be carefull because you can loos the picture e-mail me for more info

Apr 07, 2008 | Sony KP-53XBR45 53" Rear Projection...

3 Answers

TV not working- Sony Videoscope XBR


Might be a bad High Voltage Distribution block, you will want to call a trained tech to diagnose something a little knowledge can be dangerous with stuff like this.

May 19, 2007 | Sony Grand WEGA KDP-57XBR2 57" Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Projection Televisions Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ap12
Ap12

Level 2 Expert

103 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sony Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...