TAKE LINK OUT OF WATCH BAND
KENNETH COLE RECTION KC3555
repman I've tried tapping out the pins on my Kenneth Cole Watchband, but they will only come out about a couple of millimeters; not enough for me to grab onto with a small pair of pliers. Any ideas?
I found a pushpin small enough to fit down into the hole and was able to push out the pin in the band far enough to get a hold of it with a pair of pliers and pull it out. Repman was right, they are in very tight and it takes some "elbow grease" to get them out.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I would try a local watch repair place first to see if its a standard type pin. If not you will need to follow this advice.
Watches bought from Kenneth Cole or a Kenneth Cole retailer are covered by a limited lifetime warranty. The warranty does not cover repairs needed because of normal wear and tear. You will need :
Check or money order for $8.50
Write your name, address, phone number and a description of the problem on a sheet of paper.
Put the watch and the paper with your information in a padded envelope.
Mail your package to:
Kenneth Cole Productions Inc. Attn: Returns Department 229 Hollie Drive Martinsville, VA 24112
are you talking about the band pins or the lug pins? most watch repair stations will have lugs and pins, and will replace for about $5...any more and you will be getting ripped off. Lug pins are a pain and unless you have the proper lug tools, you can end up scratching the finish of the watch...be careful!
Start by looking at the inside of the watchband, there should be a arrow pointing up/down. Take a pin and put it in on the side that shows the arrow going down. Take a hammer and GENTLY tapp the pin. The pin should push out a pin in the band. Do this as many times as you have to for the size you desire, and then put the pin in the same derection as you tapped the pin out. Usually you will also see a **** on the side youn DON'T want to tap out. If you still; have a problem don;'t hesitate to write me, and I will be glad to take you step by step with this. Good Luck!!