- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sounds like you either have econo-mode set which would be in the printer driver or your screen colors do not match your printer colors. Your easiest test is to open mspaint and create a block of just one basic color like yellow. If it prints fine then the programs you are trying to use are not sending the right color instructions to the printer. Never expect a low end color such as this to match your screen out of the box, it will not happen. You either have to accept the color difference or spend the money to buy a color matching device which creates custom drivers for your printer and screen so they look the same.
The scanner assembly is dirty. Remove all the toner and blow with blower or cold air dryer, in the gaps at the back of the printer. If it still printers faded then the printer must be stripped and the scanner taken out and serviced. (About 1.5 hours work by expierenced technician)
Good day sir/maam, hi, when you test print it usually prints letters and no lines are printed. try first if the printer is setup to economy/draft or pictures, if lines are faded, the ink cartridges maybe dirty. manual cleaning is needed, the ink path starts from the ink cartridge to the cradle or carrier then to paper. so any dried ink that blocks the path can affect the printout. you can use warm water to loosen dried ink. remove the cartridges and cradle from the printer as you clean them.
thats not the test page that is allignment page which is printing.
keep the the printed side of that page which comes out on the scanner glass.press the ---scan ---button.the on /off light will blink, wait till it stops blinking.and after that everything will be normal.