Dvd won`t work correctly

Does your subs play when you are playing a cd?If yes then you need to check the turn on lead for your sub amp and make sure your jensen deck is putting 12 volt out when your dvd is playing.If it is not you need to find the correct amp turn on wire, if it is then you may have to re equilize your sound when you are playing dvds.

Go to MyComputer - Properties - Hardware - Device Manager . Right click on your DVD drive and select properties. Select the region tab and enter your correct region in the box provided.

Must reset lazer lens manually. Most of the time this does the trick. hope this helps you

connect the red wire to the negative on your battery run it straight to it and it will always play so you don't have to pull up your e~brake

How is the dvd player connected to the tv?

check da ground wire

If you have the VM9410 then there is a way to play dvd's even when you are driving. You must ground out the pink wire in the harness. This allows you to watch dvd's even when driving. good luck!

You have to use a sequence of the brake, on/off/on, for 3-5 seconds at a time, in order for it to play. Want an easier way? Try this:

This will work with out haveing to do anything to the pink wire just tape it and leave it alone. But the next time you unhook ur battery cable you will have to put the code in again.
Put in DVD
right when the blue screen comes up
hit STOP twice
punch in 1,2,6, and 4
hit DOWN 1 time not 2
hit PLAY/ENTER
**at this point the display became visible and i could now see the menu which made it much easier.
hit DOWN one more time to change macrovision
hit PLAY/ENTER
hit SYS SETUP twice to save and exit menu

I did it on mine and it works perfectly - no more messing with switches and ebrakes:)

I have the same problem with the same head unit except mine is new out of the box. Is this a factory defect or is it something I can fix

two things might be wrong is there 12 volts and is there a good ground . hope this might help.