An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert who has answered 1,000 questions.
Re: CD CHARNGER PROBLEM
If you put in a new lens it would have to be aligned to properly read discs. This usually requires some high-tech gear to do so.
Most troubles I come across with CD/DVD players is that the chrome rails that the transport moves along have gotten dirty. Clean them with a swab wet with WD40 then clean with a new swab and then treat the rail with silicone lube
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Well the first thing to try is a cd lense cleaner. You may have a build up of prticles and oil on the lense causing it not to read. Secondly, make sure you try a "Shop Purchased" cd to make sure it's not haveing problems reading "cdrs" (home made cds).
If after both of these methods you still have the same problem, it's down to the laser. Could be a series of things from tracking, focussing or the laser has died altogether. Unles your experienced with electronics in a big ay and have test meters and an oscilloscope, you need to decide how much you want to keep this CD player as a new one could be cheaper than a repair.
My Bose Wave Radio/CD developed this problem about a year ago. I don't use the CD player much and kept the unit clean. The disc spins but, the system does not read it. Cleaning the lens with cotton did not help.
The problem of "'no discs'"displayed is in the mechanism in the roller thats moving back and port bringing the lense set .The old grease thier is already hardened that cause the problem.Clean that by using a lighter fluid or like that fluid to take the old grease,and put it with a new one first class grease type-A grease put only a little grease and wipe the lense with a cotton buds without any chemicals on it .Try this solution so performance will be better.
The first thing to try is cleaning the lenses,sounds obvious,but i think thats why its continuing to try :initialising: if that fails the lense that reads the disc or both likely need realigning most problems that acure whith any cdplayers ect are down to the lenses.
even if the laser lense cant process the data being read it should not eject and just display disc error or no disc. That's how it normally does. anyway if is is different from yours, try cleaning the laser lense with cotton bud, dampen a bit with rubbing alcohol, then the other end to dry it. rub it in circular motion please and not too hard or excesiove force on it.
lubricate the spindle motor shaft if you can reach, not too much oil, the very thin type household use only. likewise the traverse mech. the mech is not the source of your problem but since you are lubricating the spindle motor then you might as well lubricate the rest of moving parts. try not to put oil in you platine table and other rotating parts like the rubber belts or you'll find another problem later.
This message usually indicates that a non-audio disc is in the record tray. Please use only blank music CD-R or CD-RW media.
Refer to page 12 of the owners manual for more information regarding acceptable media type for the DA-3826.
Also, the laser lens in your CD might be dirty or failing.
Try the following solutions:
Clean the laser lens with a CD player lense cleaning disc.
Lense cleaning discs are available at many electronics retail store.
Sorry i can't help you more.