Question about Heaters

1 Answer

I need a cooks essentials item

I ordered the cooks essentials buffet server with three trays on qvc, and i also ordered the set of 2 large buffet inserts, which were on back order. I just received an email that the 2 large inserts are no longer availalbe, and I want to know if there is anywhere I can purchase them? Thank you

Posted by on

  • 2 more comments 
  • eyedoc68 Dec 23, 2008

    I have the same problem. Would like to find the two larger pans to fit the 3 pan unit. eyedoc68

  • Anonymous Dec 31, 2008

    I have the same problem. Need to get the inserts especially since I have 2 of the 3 buffet servers.

  • Cheryl_Keife Jan 14, 2009

    Same problem. And I really wanted the larger trays instead of the smaller ones. Help!

  • kwaldron1957 Jan 14, 2009

    I have the same problem. Would like to find the two larger pans to fit the 3 pan unit.


×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

From time to time I see them on mrpearl11.com. Last year I had a big party for Halloween and needed the buffet inserts badly. After scouring the web, I finally found them. The closer it came to the date of my party, the more stressed I became. Finally, I found them at Mrpearl11.com. I saw them on the site earlier in the year but I didn't really need them at that time. Hope that helps.

Posted on Sep 30, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heat 1 & 2


Typically 'Heat 1' means first stage heat and 'Heat 2' means second stage heat. Essentially a Lo and Hi setting. Just like a hair dryer.

Feb 26, 2014 | Patton PUH680-U Utility Heater

1 Answer

The heater smells like oil


Take a colored paper towel and rub over EVERY joint and seam. It sounds like you have a small leak that isn't dripping but it is cooking. There will be oily residue where the leak is located.

Dec 13, 2012 | Heaters

1 Answer

I have a Coleman/Evcon furnace model #DGU08016UB that has a concern. In my attempt to check my furnace before we need it for the winter; the following condition occurred. Condition: Flashing code of...


jump out pressure switch see if it lights check hose to pressure switch see if they are split or connections are not good ,cut off ends and put back on presure switch.

Sep 21, 2011 | Coleman Heaters

1 Answer

Rheem Highboy Oil Furnace runs, then shuts down. I throw in a lit paper to burn off oil residual from failed start. Hit 'Reset' button and furnace starts up. It may start up by itself for the next 3...


Oil furnaces have certain items that routinely go bad or need adjusted to work properly.Some of the common things are nozzle, then gap and location of the igniter,then last is the fire eye. You can see all of these items by pulling the burner tray out. The nozzle delivers the fuel in two ways more or less, first is spray angle then second is the rate or GPH. Nozzles are to spray an atomized mist this means no heavy droplets of fuel. If you have large drops of oil chances are a new nozzle can help you out, please pay attention to spray angle and GPH. The igniter is next, after time they will wear and you can clean the rods and reset the gap to specified distance, that being said it also needs to be a certain distance from the atomized fuel to ignite properly all very important. Then last is the fire eye it tells the furnace that a flame is established and to deliver fuel or flame out and shuts fuel down. These will build carbon deposits at times so simply clean off the deposit and clean the lens with a soft cloth and windex reposition put the burner tray back in hook up the fuel line and off you go.

Dec 20, 2010 | Heaters

1 Answer

Have a rheem criterion II. Model


The way it lights is that the gas is spread from one burner to the next by either a flame tray or small holes drilled in the burner tubes. If the flame does not get all the way across the burner tubes within a few seconds, the unit goes out on failure. Clean and inspect each burner tube, not just the orifice. Clean any tray that connects the burners. You can use a small wire brush or tooth brush but be careful near the glow igniter as it is very fragile.

Dec 12, 2009 | Heaters

1 Answer

I turned my propane fireplace on and it set my smoke alarm off. We have lived here for three years and never had this problem before. Please advise.


check to see if the flame is pure blue. if not you have incomplete combustion letting CO or CO2 into the room. The flame will look yellow if this is the case. An orange flame indicates dust and dirt around the burner assembly. If it is yellow, the should be 1-2 set screws on the back of the burner assembly that will let you adjust the primary air being mixed with the propane.Adjust until you get blue flame and tighten set screws.

Dec 05, 2009 | Vanguard International Blue Flame - Large...

1 Answer

Need to Know Where to Change the Furnace Filter


On the bottom of the indoor unit should be a cover or tray. Sometimes a large grill inside the house, close to the unit is where they are placed. Good luck

Apr 23, 2009 | Goodman Heaters

1 Answer

Doesn't turn off


only three options here first check for shorted wires , second bad thermostat (try unplugging thermostat wires one at a time if possible to see if unit turns off, this will also tell you if the gas valve is stuck open if you take all the wires off the thermostat and the thing still reuns, ) good luck.

Mar 28, 2008 | Procom QL300TYLA Heater

3 Answers

Replacement Parts


This is made in China and parts are not easily available, you could try a hardware store as they sometimes have various wheels. I looked at mine and it appears that a 2" block of wood zip tied might also be the right height to keep it from tipping if a wheel can't be found.

Nov 09, 2007 | DeLonghi 6707E Oil Filled Radiator Heater

Not finding what you are looking for?
Heaters Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heaters Experts

paulcarew

Level 3 Expert

1875 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Mack Baxter

Level 3 Expert

379 Answers

Are you a Heater Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...