Question about Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
SOURCE: HOOVER STEAM VAC SPIN SCRUB
Check the flexible hose that comes down from the handle. Look for a crack where it plugs into the base unit. (visible once you open the handle up and remove the cleanable catch basket)
Posted on Oct 22, 2007
SOURCE: Hoover Steam Vac Spin Scrub
Remove the brush block, is the shaft on it or broken off. Replace the block if broken off. Turn unit over, with brush block removed, handle tilted back, is the square hole turning, if not then the turbine is bad, this is what turns the brushes.
Posted on Sep 01, 2008
If you don't have the user's manual for the machine, here it is:
Check your system for any obstructions that could possibly causing the problem. Also, remove the brushes and see if there's a problem between the brushes and the motor.
Posted on Aug 25, 2009
I fixed my problem by repositioning the tunnel that is on the front of the pick-up tank. It had moved out of position and not allowing a tight seal. It is the white plastic piece that slides a little bit. Good luck.
Posted on Jun 13, 2010
To fix mine: I removed the brush assembly, showing that when the machine was powered on, the square of the drive gear was not spinning. I used a flat heat screwdriver and inserted it into the square, then gently worked it back and forth until the turbine was free. Then I squirted household oil down into the hole before replacing the brushes. Has been working fine ever since.
Posted on Jul 01, 2010
Tips for a great answer:
Jun 22, 2012 | Hoover F5906-900 Upright Steam Vacuum
Aug 25, 2009 | Hoover SteamVac F5914-900 SpinScrub...
Jun 13, 2009 | Hoover SteamVac F5914-900 SpinScrub...
Dec 20, 2008 | Hoover Steam Vac Dual V w/ SpinScrub...
Jul 01, 2008 | Hoover SteamVac Carpet/Upholstery Deep...
Jun 02, 2008 | Hoover SteamVac F5914-900 SpinScrub...
117 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: